Loading ...
Loading ...
Loading ...
34
Problem Possible Causes What To Do
Display goes blank
A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is in the • See the
Special features of your oven control
section.
black-out mode.
Display flashes
Power failure. • Reset the clock.
Unable to get the
Oven control pads were • The
BAKE
and
BROIL HI/LO
pads must be pressed
display to show “SF”
not pressed properly. at the same time and held for 3 seconds.
Power outage,
Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes
it by pressing the
CLEAR/OFF
pad, setting the clock
and resetting any cooking function.
“Burning” or “oily”
This is normal in a new • To speed the process, set a self-clean cycle for a
odor emitting from
oven and will disappear minimum of 3 hours. See the
Using the self-cleaning
the vent
in time.
oven
section.
Strong odor
An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Drawer does not slide
Drawer is over-loaded or • Reduce weight. Redistribute drawer contents.
smoothly or drags
load is unbalanced.
Warming drawer will
A fuse in your home may be • Replace the fuse or reset the circuit breaker.
not work
blown or the circuit breaker
tripped.
Controls improperly set. • See the
Warming drawer
section.
Excessive condensation
Liquid in drawer. • Remove liquid.
in the drawer
Uncovered foods. • Cover food with lid or aluminum foil.
Temperature setting too high. • Reduce temperature setting.
Food dries out in the
Moisture escaping. • Cover food with lid or aluminum foil.
warming drawer
Drawer not fully closed. • Push drawer in until latch engages.
Troubleshooting Tips
Before you call for service…
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Loading ...
Loading ...
Loading ...