Loading ...
Loading ...
Loading ...
40
Before You Call For Service…
Wall Oven
Trouble-
shooting tips
PROBLEM POSSIBLE CAUSE
OVEN DOOR WILL • The oven is too hot. Allow the oven to cool below locking
NOT OPEN AFTER temperature.
A CLEAN CYCLE
OVEN NOT • Oven controls improperly set. See the Using the Self-Cleaning Oven
CLEAN AFTER section.
A CLEAN CYCLE
• Oven was heavily soiled. Clean up heavy spillovers before starting the
clean cycle. Heavily soiled ovens may need to self-clean again or for a
longer period of time.
“LOCK DOOR” • The self-clean cycle has been selected but the door is not closed.
FLASHES IN Close the oven door.
THE DISPLAY
LOCKED DOOR • The oven door is locked because the temperature inside the oven has
LIGHT IS ON WHEN not dropped below the locking temperature. Press the CLEAR/OFF
YOU WANT TO COOK pad. Allow the oven to cool.
CONTROL SIGNALS • You forgot to enter a bake temperature or cleaning time. Press the
AFTER ENTERING BAKE pad and desired temperature or the SELF CLEAN pad and
COOKING TIME OR desired clean time.
DELAY START
“F—AND A NUMBER • You have a function error code. Press the CLEAR/OFF pad. Allow
OR LETTER” FLASH the oven to cool for one hour. Put the oven back into operation.
IN THE DISPLAY
• Disconnect all power to the oven for 30 seconds and then reconnect
power. If the function error code repeats, call for service.
DISPLAY GOES • A fuse in your home may be blown or the circuit breaker tripped.
BLANK Replace the fuse or reset the circuit breaker.
• The clock is in the black-out mode. See the Oven Control, Clock and
Timer section.
DISPLAY FLASHES •Power failure. Reset the clock.
UNABLE TO GET •Oven control pads were not pressed properly. The BAKE and the
THE DISPLAY TO BROIL HI/LO pads must be pressed at the same time and held
SHOW “SF” for 3 seconds.
“PROBE” APPEARS • This is reminding you to enter a probe temperature after plugging
IN THE DISPLAY in the probe. Enter a probe temperature.
POWER OUTAGE, • Power outage or surge. Reset the the clock. If the oven was in use,
CLOCK FLASHES you must reset it by pressing the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
STEAM FROM • When using the convection feature, it is normal to see steam coming
THE VENT out of the oven vent. As the number of shelves or amount of food
being cooked increases, the amount of visible steam will increase.
“BURNING” OR • This is normal in a new oven and will disappear in time. To speed
“OILY” ODOR the process, set a self-clean cycle for a minimum of 3 hours. See the
EMITTING FROM Using the Self-Cleaning Oven section.
THE VENT
STRONG ODOR • This is temporary. An odor from the insulation around the inside of
the oven is normal for the first few times the oven is used.
FAN NOISE • A cooling fan or a convection fan (depending on the function
you are using) may automatically turn on and off. This is normal.
The cooling fan will turn off and on. The convection fan will run
until the function is over or the door is opened.
Loading ...
Loading ...
Loading ...