Loading ...
Loading ...
Loading ...
If you experience Recommended Solutions
The START indicator
is ashing
■ If the START light is ashing, press START and close the door within 4 seconds. If the Clean light or
any other lights are blinking and the dishwasher will not run.
Dishes do not dry
completely
NOTE: Plastic and items with nonstick surfaces are difcult to dry because they have a porous surface
which tends to collect water droplets. Towel drying may be necessary. Use of rinse aid along with the Heat
Dry option is needed for proper drying. Proper loading of items can affect drying.
Glasses and cups with concave bottoms hold water. This water may spill onto other items when you are
unloading the dishwasher.
■ Unload the bottom rack rst.
Noise NOTE: Common noises:
■ Surging sounds can occur periodically throughout the wash cycle and during the drain cycle.
■ Normal water valve hissing may be heard periodically.
■ A normal snap sound may be heard when the detergent dispenser opens during the cycle and when the
door is opened at the end of the cycle.
■ Improper installation will affect noise levels.
■ A thumping sound may be heard if items extend beyond the racks and interfere with the wash arms.
Readjust the dishware and resume the cycle.
Spotting/Filming Liquid rinse aid is necessary for drying and to reduce spotting.
Use the correct amount of detergent.
Conrm that the cloudiness is removable by soaking the item in white vinegar for 5 minutes and dry the
item. If the cloudiness disappears, it is due to hard water. Adjust the amount of detergent and rinse aid. See
the “Dishwasher Care” section. If the cloudiness on glass does not come clear, it is due to etching.
Be sure the incoming water temperature is set at 120°F (49°C).
Try using the Hi-Temp Wash or Sani Rinse options.
Dishwasher does
not clean completely
Be sure the dishwasher is loaded correctly. Improper loading can greatly decrease the washing
performance. Check that all spray arms spin freely.
Select the proper cycle for the type of soils. The Auto or PowerBlast
®
cycle can be used for tougher loads.
Be sure the incoming water temperature is at least 120°F (49°C).
Use the proper amount of fresh detergent. More detergent is needed for heavier soiled loads or hard water
conditions. Scrape food from dishes prior to loading (do not prerinse).
If foam or suds are detected by the dishwasher sensing system, the dishwasher may not operate properly
or may not ll with water. Suds can come from:
■ Using the incorrect type of detergent, such as dish detergent for hand washing dishes, laundry
detergent.
■ Loading dishes that have been prewashed with handwash dishwashing detergent without rinsing them.
■ Not replacing the rinse aid dispenser cap after lling (or relling) the rinse aid.
■ Using an excessive amount of dishwasher detergent.
Dishwasher does
not drain
Be sure the cycle has been completed (the Clean light is on). If it has not, resume the cycle by closing the
door and pressing START.
If dishwasher is connected to a food waste disposer, be sure the knockout plug has been removed from the
disposer inlet.
Check for kinks in the drain hose.
Check for food obstructions in the drain or disposer.
Check your house fuse or circuit breaker.
Loading ...
Loading ...
Loading ...