Loading ...
Loading ...
Loading ...
8 9
UNPACKING YOUR FREEZER
1. Remove all packaging material. This includes the foam base and all adhesive tape holding the
freezer accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before powering on the
freezer.
ADJUSTING YOUR FREEZER
• Your freezer is designed for freestanding installation only. It should not be recessed or built-in.
• Place the freezer on a surface strong enough to support it when fully loaded.
• When moving the freezer, never tilt it more than a 45-degree angle. This could damage the
compressor and the sealed system.
• If the freezer is tilted let it stand in an upright position for at least 24 hours prior to plugging in.
This is to allow the refrigerant to settle.
PROPER AIR CIRCULATION
• To assure your freezer works at the maximum effciency it was designed for, you should install it in a
location where there is proper air circulation, plumbing and electrical connections.
• Recommended clearances around the freezer:
Sides……………4” (102mm)
Sides……………4” (102mm)
Top....................4” (102mm)
WARNING:
ELECTRICAL REQUIREMENT - SHOCK HAZARD
ELECTRICAL REQUIREMENT
• Make sure there is a suitable power Outlet (115 volts, 15 amps outlet) with proper grounding to power
the freezer.
• Avoid the use of three plug adapters or cutting off the third grounding in order to
accommodate a two plug outlet. This is a dangerous practice since it provides no effective
grounding for the freezer and may result in shock hazard.
WARNING:
USE OF EXTENSION CORDS- POTENTIAL SAFETY HAZARD
Operating Instructions Operating Instructions
USE OF EXTENSION CORD
• Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is
necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance. DO NOT USE EXTENSION CORD LONGER THAN 12 FT.
INSTALL LIMITATIONS
• Do not install your freezer in any location not properly insulated or heated e.g. garage etc. Your
freezer is not designed to operate in temperature below 55˚F.
• Select a suitable location for the freezer on a hard even surface away from direct sunlight or heat source
e.g. radiators, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected.
OPERATING YOUR FREEZER
• Once the freezer is in its proper place, plug it in an electrical outlet having 115 volts and 15 amps.
• Set the temperature on the temperature control dial. “1” being the warmest and “7” being the
coldest. Initially set the temperature on “4”. Place food inside the freezer. After 24 hours set the
freezer to your desired setting.
• In case you unplug your freezer or experience an electrical outage, allow 5 minutes before plugging it
back in.
GENERAL FEATURES
Temperature control dial:
Your freezer will automatically maintain the temperature level you select.
0
7
6
5
4
3
2
1
Lock function:
Insert the key and turn clockwise to lock. Turn counter-clockwise to unlock.
Loading ...
Loading ...
Loading ...