Loading ...
Loading ...
Loading ...
2
2. INSTALLATION
2.1 Location
When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator.
Also avoid direct sunlight as it may increase the electrical consumption. Extreme cold ambient
temperatures may also cause the unit not to perform properly. This unit is not designed for use in
a garage or outdoor installation. Do not drape the unit with any covering.
When installing the unit, ensure that 1/8 inch of free space is left at both sides, 1 inch at the rear
and 1/8 inch at the top of the unit. This will allow cold air to circulate around the refrigerator and
improve the efficiency of the cooling process.
2.2 Door Handle Install Illumination
Note: Figures in the user manual are only for reference. The actual product may differ slightly.
The refrigerator must be disconnected from the source of electrical supply before attempting the
installation of accessory.
(Pictures and objects are not consistent, in order to prevail in kind)
① Take out the two crisscross-screw; and install them into the door holes; turn the screws till to
the bottom;
② Aim at screws to install the handle;
③ The screws in the hole at the side of the handle and turn the screws till them very tight;
④ Screw cap should be put on the screw.
Loading ...
Loading ...
Loading ...