Loading ...
Loading ...
Loading ...
Do not obstruct or cover the ventilation aperture.
Do not allow children to play with the appliance, or to sit on it or to
hang onto the door(S).
Make sure there is a suitable power Outlet (220 volts, 13 amps outlet)
with proper grounding to power the refrigerator.
BEFORE USING FOR THE FIRST TIME
Do not position this appliance with its rear panel directly against a wall.
For good circulation and operating efficiency, the ventilation grilles
must never be blocked.
Remove all packaging and place the chiller on a stable, secure flat
surface. Position the chiller away from heat sources, where the unit is
well-ventilated and protected from moisture, or extremes of heat or cold.
The refrigerator may not function properly if the temperature rises
above +30 (standard models). The refrigerator meets the operating
conditions according to the standard EN 441-4 in climate class 4.
A 10A fuse is fitted. Never replace with a fuse rated higher than this.
NEVER USE AN EXTENSION LEAD. If the mains cable will not
reach the nearest socket, either rearrange your store layout or ask a
qualified electrician to fit a new socket.
If power is cut off, wait for at least 5 minutes before plugging the unit
in again to avoid damaging the compressor.
Do not place combustible, explosive or volatile articles, corrosive acid
or alkali, or liquid in glass containers into the chiller. Always exercise
caution if adjusting the temperature.
-4-
OPERATION
Place the shelves firmly on their supports. The maximum load for a
shelf is 40Kg. Check that the refrigerator is functioning properly before
installing and filling it. The electronically thermostat is located inside
the unit. An optional light switch is inside the unit.
Never put warm or hot foods directly into the chiller.
ELECTRONICAL THERMOSTAT
Press the “SET” key more than 3 seconds, the
display will flash, select the desired target
temperature by pressing the “SET” key,
the temperature may be adjusted between 2-12℃.
CLEANING
1. UNPLUG your Husky chiller and remove any stock to a suitable
back-up chiller.
2. Wash the inner compartment with warm water and neutral detergent.
DO NOT allow the control panel, cables or plug to get wet.
NEVER use corrosive detergents, wire brushes, or abrasive scourers to
clean your chiller.
NEVER use metal or sharp implements to remove debris.
3. Dry all surface thoroughly.
4. To ensure trouble-free operation the condenser should be cleaned
every three months where appropriate using a vacuum hose. The
condenser is located behind lower grill of the cabinet. In exceptionally
dusty
-5-
IMPORTANT: allow the refrigerator to stand
upright for 8 hours before plugging in.
SET
¡ æ
Loading ...
Loading ...
Loading ...