Loading ...
Loading ...
Loading ...
7
Tab
Slot
4. Trim fan wires.
Depending on the length of downrod you
use, you may want to cut the fan wires to
simplify wiring. After pulling the wires all the
way through the downrod, measure 8 inches
of wire. Cut o the excess wire using wire
cutters (not included).
5. Strip 1/2” of wire insulation.
Strip 1/2 inch of insulation from the end of
each wire. Twist the stripped ends of each
wire strand.
Note: If you didn’t trim the wires in the
previous step, this step is not necessary.
6. Hang downrod in mounting
bracket.
Install the ball end of the downrod into the
opening of the mounting bracket. Align the
slot in the ball with the tab on the mounting
bracket.
Proceed to FINAL INSTALLATION, page 9.
DOWNROD OR ANGLE MOUNTING
Failure to align the slot in the ball with the
tab on the mounting bracket may cause
the fan to fall, which could result in injury
or death.
8 in.
Loading ...
Loading ...
Loading ...