Loading ...
Loading ...
Loading ...
21
2. Move the door strike
Using a TORX
®
T25
®
screwdriver, remove the two screws
securing the door strike to the door frame of the dryer.
Remove the four screws above and below the door strike
and set aside for later use. Rotate the strike 180° and attach
to the opposite side of dryer door frame, as shown.
3. Remove inner door from outer door
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, remove the 13 screws securing the
inner door to the outer door. Lift off the inner door and set
aside.
NOTE: There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar at object between the inner
and outer doors at the locations shown to release the tab.
Release tab
4. Remove hinge and latch
from inner door
Using a TORX
®
T25
®
screwdriver, remove the three TORX
®
screws securing the latch plate and the ve screws holding
the hinge assembly in place.
Latch
Hinge
Release tab
5. Reinstall hinge and latch on
opposite sides
Using a TORX
®
T25
®
screwdriver, reinstall the latch plate and
hinge assembly on the opposite sides from which they were
removed.
Hinge
Latch
Loading ...
Loading ...
Loading ...