Loading ...
Loading ...
Loading ...
Observe the oven burner flame to determine if it is right.
It should be steady with a blue cone approximately 1 "
long and should not extend out over the edges of
baffle. For LP Gas, this will most likely occur when the
air adjustment shutter is completely open (see figure
12>.
Turn Oven Temperature to 300°F and allow oven burner
to cycle on and off.
To replace broiler or storage drawer, reverse steps taken
for removal (see the Use and Care Guide for complete
instructions). Replace oven racks.
Model and Serial Number Location
The serial plate is located on the left side inner trim of
the oven.
When ordering parts for or making inquires about your
wall oven, always be sure to include the model and
serial numbers and a lot number or letter from the serial
plate of your appliance.
Your serial plate also tells you the rating of the burners,
the type of fuel and the pressure the wall oven was
adjusted for when it left the factory.
Stepping, leaning or sitting on the
oven door or drawer can result in serious injuries
and also cause damage to the appliance.
Be sure to keep appliance clear of combustible
materials, gasoline and other flammable vapors
and liquids.
Before You Call for Service
Read the Avoid Service Checklist and operating and
cleaning instructions in your Use and Care Guide.
Check to make sure the house fuse or circuit breaker for
your wall oven is not blown or open.
11. Check Operation
Refer to the Use and Care Guide packaged with the wall
oven for operating instructions and for care and
cleaning of your appliance.
Do not touch the oven burners. They may be hot
enough to cause burns.
1. Check the Igniters (some models)
Operation of electric igniters should be checked
after oven and supply line connectors have been
carefully checked for leaks and oven has been
connected to electric power.
2. Oven Igniter System
Close the door and turn the Oven Temperature to
300%. In approximately 60 seconds, the burner
should ignite and stay on until oven reaches 300%.
Burner should then cycle on and off to maintain an
average temperature of approximately 300°F.
Care, Cleaning and Maintenance for Wall
Ovens
If removing the wall oven is necessary for cleaning or
maintenance, shut off gas supply. Disconnect the gas
and electric supply. Remove the installation screws from
front frame and lower trim. Pull out only as far as
necessary to disconnect the electric supply line. After
disconnecting the gas and electric supply, finish
removing the unit for servicing and cleaning. Reinstall in
reverse order and make sure that appliance is level;
check gas connection for leaks.
When All Hookups are Complete
Make sure all controls and programmable timer are left in
the OFFposition.
Reset all controls to the "OFF" position after using a
programmable timing operation.
7
Loading ...
Loading ...
Loading ...