Loading ...
Loading ...
-3-
ASSEMBLING PROCEDURES
-4-
POPPING INSTRUCTIONS
1. Follow assembly procedure.
2. Make sure the popcorn maker is unplugged before you do any of the
following.
3. Before using the unit, please check carefully to be sure voltage (AC240V
~50Hz) is suitable to your home.
4. Clean the internal surface of the kettle with warm soapy water, rinse well
and dry with clean cloth. Wipe down inner and outer housing with damp
cloth.
5. Main unit has a 2-function switch as follows:
-LIGHT: to turn light on;
-POP: to turn motor & heater on.
6. Insert the internal plug into the socket.
7. Plug the power cord into an electric outlet.
8. Before pouring oil or kernels, lift lid up using the lid tab. Turn both LIGHT &
POP switches to on position. The light, heater and motor will be on. Let
the kettle preheat about 2 to 3 minutes. Turn the POP switch to off position
and add oil (1 tablespoon of vegetable, corn, peanut, or sunflower oil).
Immediately add 1/3 cup of corn kernels (Note: 1/3 measuring cup included)
and close lid to the kettle. Turn POP switch on again, stirrer will begin to
rotate and heater will heat up the kettle. CAUTION: Lid might be hot – it is
recommended to use an oven mitt.
9. Popcorn starts popping out through the lid after about 2 minutes.
10. When unit is finished popping – you will no longer heat the corn popping –
immediately turn the POP switch to the off position and pull down the
handle bar of the kettle to release any remaining popcorn in the popper.
This will also stop the remaining popcorn from cooking any further and
avoid possible burning.
11. Keep POP switch off if the unit is not continuously in use.
12. Remove plug from power supply if the unit is not being used.
13. Repeat step 8 to 10 for continuous popping.
Step 1:
Hook the kettle onto the hanger
of the main housing.
Step 4:
Place the door on hinges.
Step 3:
Insert the removable tray.
Step 2:
Insert the internal kettle plug
into the socket on the inner top
of the main housing.
Loading ...