User Manual Frigidaire FFEW3026TS 30'' Single Electric Wall Oven

For all new ENERGY STAR products the EPA has
regulated that all ENERGY STAR air conditioners must
be factory set to Energy Saver (Econ) mode.
If you turn the room air conditioner off in cool mode,
and restart the unit it will default back into Energy Saver
mode.
You may select out of Energy Saver mode by selecting
the mode button, however we recommend using the
feature to help save energy.

This feature is a reminder to clean the Air Filter (refer to
Care and Cleaning section of the Use and Care Guide)
for more efficient operation.
The LED light will illuminate after 250 hours of
operation. After cleaning the filter, plug the unit back
into the power source and reset the filter by pressing the
‘Filter Reset’ button and the light will go off.

Econ mode, or Energy Saver mode, is a setting that
works similar to central AC.
The room air conditioner will turn off once the set temp
is reached; the fan then cycles on (for 20 sec.) every 10
min to sample the air temp. If the room temp is above
the set temp, the compressor will turn back on.
Since the room air conditioner is not running at all
times, this setting will help save energy while ensuring
the room temperature stays at the set temperature.

For your safety all Frigidaire air conditioners feature a 3-
prong grounding plug and current leakage detection
device.
These enhanced plugs help to detect damages to the
power cord and can be tested following a few simple
steps.
1. Press the reset button
2. Plug the cord into the power outlet
3. Press the test button, the reset button should pop up
4. Press reset button for use
5. Do not use room air conditioner if above test fails.

For most air conditioners, the filter can be found by
opening the front panel. Since it’s a reusable filter, you
can simply remove and clean using warm, soapy water.
After cleaning, allow the filter to dry thoroughly before
replacing it. You may also vacuum the air filter to
remove excess dirt and particles.
For more details regarding the air filter in your specific
model, please reference your Use & Care manual.

Room Air Conditioners, during operation, may make noise.
It is normal to hear ‘high pitch chatter’ a sound of rushing
air, gurgle/hiss, pinging or swishing and vibration. These
are all normal.

When this mode is enabled, the selected temperature
will increase by 2 °F 30 minutes after the mode is
selected.
The temperature will then increase by another 2 °F after
an additional 30 minutes. This new temperature will be
maintained for 7 hours before returning to the originally
selected temperature.
This ends the “Sleep” mode and the unit will continue to
operate as originally programmed. You may also cancel
sleep mode at any time by again pressing the sleep
button.

BTU stands for British Thermal Unit and is the rating
used for air conditioners. A BTU is defined by the
quantity of heat required to raise the temperature of one
pound of water one degrees Fahrenheit.
The higher the BTU, the larger space the room air
conditioner will cool. Use this helpful guide below to
decide which BTU is right for your area:
5k BTU: 150 Sq. Ft.
10k BTU: 450 Sq. Ft.
15k BTU: 850 Sq. Ft.
22k BTU: 1,300 Sq. Ft.
28k BTU: 1,900 Sq. Ft.

When this feature is on, the electronic air purifier is
energized to remove pollen and impurities from the air. To
cancel this feature, press the Clean Air button.