Loading ...
Loading ...
Loading ...
21
Performance Data Sheet
Models Number 5231JA2006E
Use with replacement cartridge 5231JA2006E
This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a concentration less than
or equal to the permissible limit for water leaving the system as specified in NSF/ANSI 42.
System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction
of Chlorine Taste and Odor and Nominal Particulate Class III.
Contaminant
Reduction
Average
Influent
Influent Challenge
Concentration.
Units apply to
each row
Product
Water
Average
%
Reduction
NSF
Reduction
Requirements
Max
Effluent
mg/L
Min %
Reduction
NSF Test
Nominal Particulate
Class I Particle size:
›0.5 to ‹1 um
5600000
At least 10,000
particles/ml
915 96 ≥ 85% 470000 91.6% 511032-03
Chlorine taste and
odor
1,9 mg/L 2,0 mg/L ± 10% 0,07 96,4 ≥ 50% 0.05 mg/L 97.4% 511032-03
* To a capacity of 300 gallons (1.135 L).
* Note that while the testing was performed under standard laboratory conditions, actual performance may vary.
Application Guidelines / Water Supply Parameters
Water Pressure 20 - 120 psi (0,14 - 0,83 MPa)
Water Temperature 33 ºF - 100 ºF (0,6 ºC - 38 ºC)
Service Flow 0,5 gpm (1,9 lpm)
WARNING
To reduce the risk associated with ingestion of
contaminants due to use with water that is micro
biologically unsafe or of unknown quality. Do not
use with water that is micro biologically unsafe or of
unknown quality without adequate disinfection before
or after the system.
Systems must be installed and operated in accordance
with manufacturer’s recommended procedures and
guidelines.
CAUTION
To reduce the risk of property damage due to water
leakage:
• Read and follow Use instructions before installation
and use of this system.
• Install on COLD water lines only. Comply with all
state and local plumbing codes.
• Company with all state and local plumbing codes.
Never install or operate where inlet water pressure
may exceed 125 psi (862 kPa).
• Protect filter from freezing. Remove filter in
temperatures below 34 °F (1 °C).
• Replace cartridge at specified service interval.
Cartridge MUST be replaced at least every 6 months.
• After replacing the water filter cartridge, dispense
2,5 gallons (9,46 liters) of water to purge the system,
depressing and releasing the dispenser pad in cycles
of 30 seconds ON and 60 seconds OFF. Discard
the purged water.
To purchase or replace water filters call your Service
Center. Refer to the Warranty Card to obtain the
telephone number of the Service Center near you and
ask for part no. 5231JA2006E.
*
WATER FILTER WATER FILTER
Loading ...
Loading ...
Loading ...