Loading ...
Loading ...
Loading ...
8 49-80569-3
Care and Cleaning
Stainless Steel Hood
NOTE: The glass cover should be removed
only when cool.
CAUTION
Before replacing the bulb,
disconnect electrical power to the hood at the
main fuse or circuit breaker. Allow bulbs to
cool before touching.
Be sure to let the light cover and bulb cool
completely.
For safety, do not touch a hot bulb with bare
hands or a damp cloth.
To change the light bulbs:
1. Remove the lamp lens cover by inserting a
small flat-blade screwdriver into each of the
three slots and gently prying it free.
NOTE: Do not remove the outer trim ring
(lamp assembly).
2. Grasp the bulb and pull it straight out.
3. Using gloves or a dry cloth, remove the new
bulb from the packaging. (Wearing latex
gloves may offer a better grip.) The bulb
must be the same wattage, 120-volt, 25-watt
halogen with a G-9 base. Early bulb failure
may occur if wattage is too high.
4. Push the bulb straight all the way into the
receptacle.
5. Replace the lens cover by inserting the
three retaining tabs into the slots and
pressing into place.
NOTE: For improved lighting, clean the glass
cover frequently using a damp cloth. This should
be done when the hood is completely cool.
6. Reconnect electrical power to the hood.
NOTE: Order replacement 120-volt, 25-watt
halogen bulb with G-9 base, WB25X10020.
These bulbs can be ordered from your
Monogram supplier.
NOTE: Make sure the tabs are inserted into
the slots.
ONLY use a new 120-volt, 25-watt halogen
bulb with a G-9 base.
NOTE: Do not touch the new halogen bulb
with bare fingers. Skin oils can cause early
lamp failure.
Light bulbs
Use a small flat-blade screwdriver
to remove the lamp lens cover.
Outer trim ring (lamp
assembly) Do not
remove
Bulb
Removable inner
lamp lens cover
Tab
Receptacle
Use gloves
or cloth
Loading ...
Loading ...
Loading ...