Loading ...
Loading ...
Loading ...
51
OPERATION
Starting the Engine
Starting a Cold Engine
1. Place the transmission in neutral and
lock the parking brake. Make sure the
fuel valve is on.
2. Sit on the vehicle and pull t he choke
knob (1) out until it stops. NOTE: If
the knob doesn’t stay where positioned,
increase the tension by rotating the tension
adjusting nut (2) clockwise.
NOTE: The variable choke is fully on when the
knob is pulled completely out. The choke is
off when the knob is pushed completely in.
The choke can be adjusted gradually, depending
on how much choke is needed for starting. Be
sure the choke is off during operation, as excess fuel
washing into the engine oil will increase wear on engine components.
3. Move the engine stop switch to RUN. NOTE: Do not press the
throttle while starting the engine.
4. Turn the ignition key past the ON position to engage the starter for
a maximum of five seconds. Release the key when the engine
starts. If it doesn’t start, release the key and wait five seconds.
Activate the starter for another five seconds. Repeat until the
engine starts.
5. If the engine slows or stops, position the choke knob half way in to
allow proper engine warm up.
6. Vary the engine RPM slightly with the throttle to aid in warm-up.
When the engine idles smoothly, push the choke all the way in.
Engine exhaust contains poisonous carbon monoxide and can
cause loss of consciousness resulting in severe injury or death.
Never run an engine in an enclosed area.
WARNING
Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several
minutes before operating the vehicle.
CAUTION
1
2
Loading ...
Loading ...
Loading ...