Loading ...
Loading ...
Loading ...
30
INSTALLATION INSTRUCTIONS
Installation test (Exhaust check)
Once you have completed the installation of the dryer, use this
test to make sure the condition of the exhaust system is adequate
for proper operation of the dryer. This test should be performed
to alert you to any serious problems in the exhaust system of your
home.
• Your dryer features FLOW SENSE
TM
, an innovative sensing system
that automatically detects blockages and restrictions in dryer
ductwork. Keeping ductwork clean of lint buildup and free of
restrictions allows clothes to dry faster and reduces energy use.
1.
door.
Do not load anything in the drum for this test, as it may
affectthe accuracy of the results.
2.
This button sequence activates the installation test. The code
“Flow check” will display if the activation is successful.
Language
English
Français
Español
Language
English
Français
Español
Language
English
Français
Español
3.
The dryer will start the test, which will last about two minutes.
The heater will be turned on and the temperatures in the
drum will be measured.
4.
During the test cycle, monitor the FLOW SENSE
TM
display on
the control panel. If no bars are displayed, when the cycle
ends, the exhaust system is adequate. If the exhaust system
is severely restricted, the display will show four bars. Other
problems may also be shown with error codes. Refer to the
next page for error code details and solutions.
5.
At the end of the test cycle, “End Of Cycle” will display. The test
cycle will end and the dryer will shut off automatically after a
short delay.
Language
English
Français
Español
NOTE
The dryer should be cool before starting this test. If the dryer
was warmed up during installation, run the AIR DRY cycle for a
few minutes to reduce the interior temperature.
NO BARS: OK FOUR BARS: RESTRICTED
MFL67731015_en_170830.indd 30 2017.8.30 3:58:16 PM
Loading ...
Loading ...
Loading ...