Art Sensored Polar
Bear Lamp
INSTRUCTION
CHARGING
SPECIFICATIONS
Warm Light Model
Thank you for your purchase
Please read this manual carefully before use
Vl.0
/
ON
Steady on mode
OFF
Turn o the lights
AUTO
Sensor
mode.
When motion is
detected, light will
turn on for about 30
seconds then turn o.
Light will turn on
again if motion is
detected again.
Sensing distance:
1-2m in front of the lamp.
＼
STATE INDICATOR
Charging Light on
Fully charged
Light off
1. Do not use mobile phone fast charging/charging bank fast
charging/In-line fast charging port, fast charging will
damage the circuit chip.
2. Please use the output reference 5V1A or 5V1.SA adapter,
turn It o when charging, and turn It on aer charging.
PACKAGING
勹三
Manual X 1
Charge cable X 1
B
Lamp X 1
Product Name
Product Size
Product Material
Battery Capacity
Power Input
Charging Time
Interface
WARNING
Art Sensored Pola『 Bea「Lamp
9x12xllcm
S仆icone/ABS/HIPS
600mAh/3. 7V
DC5V, 0.5A
About 2.5 hours
Type
-C
• Please read the instructions carefully before using this product
• Please wipe the product with a cloth, do not use abrasive agent or
solvent, in order to avoid corrosion of silicone and electronic
•
components.
Packaging materials (such as plastic bags, bubble film, etc.) should be
•
kept out of the『each of children to avoid room breathing
• Do not place this product in a humid environment or immersed in water
LED light sources can be very strong, so don't stare at them for long
•
pe「iods of time
This light source is not replaceable. Replace the entire luminaire at the
• end of its life.
This product is not flame『etardant, do not place near the fire source. This
• product contains lithium batteries
If not used for a long time, please charge the battery to more than 50%
before storage to protect the battery life
A�i�:二二？s：：u2V?;；
o
owu：芦。rizati on
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This transmitter must not be located or operating in
conjunction with any other antenna or transmitter.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
