User’s Manual
Smart Key
FCC ID:2AOKM-HD09B
IC:24223-HD09B
MODEL:RT-HD094B
This remote has lock, unlock, and panic buttons; you can lock and unlock the vehicle doors and trunk/hatch with the
remote transmitter.
LOCK Button:
When you press the LOCK button, it locks all the doors.
UNLOCK Button:
Pressing the button unlocks the driver’s door. Pressing the button again within 5 seconds unlocks the other doors.
PANIC Button:
When you press the PANIC button, the vehicle will start sounding the horn and flushing the hazard lamp. To stop the
alarm, press any button on the electronic key.
REMOTE START Button:
Press the remote start button twice within 5 seconds. The vehicle will stay in the Remote Start mode for a
15-minute cycle. Press and release remote start button once to exit Remote Start mode.
TRUNK Button:
Pressing the button opens and closes the trunk.
FCC COMPLIANCE STATEMENT:
1.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
IC WARNING:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device
ADVERTENCIA IC
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS
(RSS)d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis auxdeux conditions
suivantes : (1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles deprovoquer un fonctionnement
indésirable de l'appareil.
