Product Specification
Number
ring
State the items Gauge lattice
1 Model FL-Y01
2
Product
storage
environment
Product use
environment
Ambient temperature
-10
℃
～
40
℃
3 Relative temperature
45%
～
75% RH
4 Atmospheric pressure
86
～
106Kpa
5 Ambient illumination (use) Natural light or fluorescent light
200Ix±50Ix
6
Product
composition
specification
(Standard
specifications
,
except special
requirements
)
Nameplate quality /
7 Plastic material 475
8 Paint material /
9 Key material Bulge
10 Circuit board material 94HB
11 Processor model STX655M
12 Remote emission source RF
13 Remote coding format /
14 Remote code watch /
15 Product appearance design /
16 Type of battery used Alkaline environmental protection
battery
17 Battery specification AAA Battery
18
Product
inspection
standard
(Unless
otherwise
stated,
Tamb=25
℃
)
Rated operating voltage DC 3V
19 Operating voltage range DC 2.6V-3.5V
20 Operating current range ≤10mA
21 Standby current ≤3uA
22 Carrier frequency 433.92Hz±40KHz
23 Transmitting power 8 to 20mAV/ time
24 Transmitting distance ≥10m (unblocked, standard
acceptance device)
25 Directional launch Angle ≥30
℃
(no Angle limit)
26 Directional firing range ≥6m (none)
27 Under voltage launch distance
≥6m (2.5V unblocked)
28 Key free height ≤3mm
29 Keying force 120±30g
30 Key load life ≥ 20,000 times
31 Free drop test 80cm (Wood floor)
32 Number of free drops 6 times (once per side)
33 Vibration test (30min) Three-dimensional direction;1.5mm
amplitude; 500-3300 times/second
34 High temperature storage test
60
℃
（
72h
）
35 Low temperature storage test
-20
℃
（
72h
）
36 Constant temperature test 40
℃
Relative humidity 90%
Remote code watch
Fixed code: FFFF
0A 0C
07 09
0D 0F
12 14
Key Manual
ON
Always ON
OFF
Always OFF
On at dusk, off at dawn
2H
On at dusk, off after 2H
4H
On at dusk, off after 4H
6H
On at dusk, off after 6H
8H
On at dusk, off after 8H
10H
On at dusk, off after 10H
Federal Communications Commission (FCC) Statement. This device complies with part 15 of the
FCC Rules. Operation is subject to the following twoconditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation. Note: This equipment has been
tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide Reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one ormore of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications made to this device not expressly approved by
Changsha Xiaoyuan Technology Co., Ltd
m
a
y
v
o
i
d
t
h
e
F
CC
au
t
h
o
ri
z
a
t
i
o
n
t
o o
p
e
r
a
t
e
t
hi
s
device.Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment.
RF exposure statement:
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. The device is installed and operated without restriction.
