Model :
AW-M1000EM
SAFETY INSTRUCTIONS
3
Model
Washing Capacity
Standard Water Pressure
0.03MPa ~ 0.8MPa
AW-M1000EM
9.0kg
cover
Clamp nut
2
Other process combinations are similarly set, as the above examples.
You can choose the following parameters : SOAK:0,10,20,30,40,50,60minutes
WASH: 0-20 minutes RINSE: 0-3 times SPIN: 0-9 minutes.
Trouble Shooting
display shows other alarm code again, contact the service center
needs to be pressed.
After the checking, try to use the appliance again, if problems persist or the
.
Note!
Description
Description
Reason
Solution
Abnormal behavior
with dangerous fault.
(brake wires,brake,sensors)
20
No washing
Inspection Items
If the water volume reached the required water level.(The washer will
not work if the water amount does not reach the required water level)
If it is set to "Preset" washing mode. (lt will only start to work until the
reservation time is reached).
No water flows in
If the inlet hose is properly connected and the water tap is opened.
If the "Start/ Hold" button is pressed after the power switch is pressed.
Abnormal draining
If the end of the water drain hose is placed very high.
If the end of water drain hose is immersed in and blocked by a pool of water.
Abnormal spin
If the top lid is closed.
If most of the clothing are at one side of the drum or if too many
clothes are loaded in the machine.
If the washer is not placed in stable condition or it is placed in an
7
7 2
7 3
7
7 5
2
Check the water tap is
opened or not.
if
Check the water level
sensor and drain pump.
Alarm for abnormal
water draining.
Alarm for lid not closed
before wash and spin.
that is
3
Others
FXX
a solution to the problem based on the table below. Otherwise, contact the service center.
Unbalanced wash load
during spinning
venly distribute the clothes in
the drum by hand.
Try to look for solutions first then call
for service, if no solutions work.
pressing the power button, please call
for service.
If
7 7 2 7 3 7 7 5 appears
during the operation , press the power
button to restart the machine.
Energy eciency test program
21
MAINTENANCE
Standard Water Pressure 0.03MPa~0.8MPa
Dimension
(W*D*Hmm)
Rated
Power
Net
Weight
Washing
Capacity
Model
Power
Supply
220-240V~, 50Hz38kg
550x565x960
450W
Including
drainhose
(W*D*Hmm)
600x635x960
9.0kg
AW-M1000EM
Use for model AW-M1000EM
- Energy test program operation ;
1. Press the "ON/OFF" switch.
2. Press the "course" button, to select the " Regular " program, and press
the water level key to set the level 8.
3. Press the start button.
