Uineer BT5.0
Uineer BT5.0
Uineer BT4.0
Uineer BT4.0
A9
Low battery,please charge
Blinking light
Hiermit erklärt Shenzhen Olin Precision Mould Plastic Co., Ltd., dass der Typ des Funkgeräts
der Richtlinie 2014/53/EU entspricht.
Par la présente, Shenzhen Olin Precision Mould Plastic Co., Ltd. déclare que le type d'équipement
radio est conforme à la directive 2014/53/EU.
Con la presente, Shenzhen Olin Precision Mould Plastic Co., Ltd. dichiara che il tipo di
apparecchio radio è conforme alla direttiva 2014/53/EU .
Por el presente, Shenzhen Olin Precision Mould Plastic Co., Ltd. declara que el tipo de equipo de
radio es conforme a la Directiva 2014/53/EU .
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired
Three lights light
up in a cycle
All the lights are on
A9
122
Uineer BT5.0
Uineer
BT4.0
Uineer BT5.0 Uineer BT4.0
Uineer BT5.0 Uineer BT4.0
Uineer BT5.0 Uineer BT4.0
Uineer BT5.0 Uineer BT4.0
FCC Requirement
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
