Operation Instructions
How to install batteries
How to play remote control car
Thank you for using our company's toy products. In order to give you a better understanding of this product,
please read the following instructions carefully before use It will bring you a different operating experience.
1. Turn the remote control car and the switch on the
remote control to the "OFF" position.
2. Use a Phillips screwdriver to open the battery cover.
3. Insert the battery as shown in the following figure.
4. Close the battery cover.
1. Turn on the remote control car/remote control switch to complete frequency matching.
2. Operate the joystick and wheel of the remote control to remotely control the vehicle's forward or backward
movement,
Left or right rotation and spray.
3. When the battery is depleted and the left and right steering becomes unresponsive,
Moving forward and backward will also slow down. At this point, the battery needs to be removed and charged.
This product is suitable for children aged 3 and above. After being assembled/charged by adults, children can
play with it.
Warning: Please do not disassemble or modify this product without authorization. Any changes may cause the
product to malfunction.
7. Rechargeable batteries can only be charged under adult supervision; The exhausted battery should be removed
from the toy;
8. It is necessary to regularly check whether the USB charging cable, plug, housing, and other components are
damaged. If any damage is found, they should be stopped from use until they are repaired completely;USB charging
cables are not toys; Cannot connect to more than the recommended number of power sources;
1. The toy car uses one 3.7V rechargeable battery; The remote control uses 2 1.5V AA non rechargeable batteries;
2. Insert and remove batteries using the correct method and polarity;
3. How to remove and insert batteries from toy cars and remote controls: Use a screwdriver to loosen the screws on
the battery cover, remove the battery cover, and insert the battery with the correct polarity Remove the battery, then
close the battery cover and tighten the screws;
4. Do not short-circuit, disassemble or put the battery into fire; Non rechargeable batteries cannot be charged; The
power terminal must not be short circuited;
5. Different types of batteries or old and new batteries cannot be mixed;
6. If not used for a long time, please remove the battery; Rechargeable batteries should be removed from toys
before charging (applicable only to toy cars);
Precautions for battery use
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However,there is no guarantee that interference will not occur in a particular installation.If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on,the user is encouraged to try to correct the interference by one or more of the following
measures：
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuitdifferent from that to which the receiver is connected.
--Consult the dealer oranexperienced radio/TVtechnician for help.
This device complies with part 15 of the FCC RulesOperation is subiect to the following two conditions:(1)This device
may not cause harmful interference, and (2) this device must accept any interference received,including interference
that may cause undesired operation.
NOTE:This device and its antenna(s) must not be co-located or operation in coniunction with any other antenna or
transmitter.
The device has been evaluated to meet general RF exposure requirement.The device can be used in portable
exposure condition without restriction
FCC Warning Statement
Sample Name:Tesla Cyber Remote Control Car
Model:NO.0855-246 MT1615
