BATTERY INSTRUCTIONS
ATTENTION: Batteries should be installed only by an adult.
- Be sure to insert batteries in the correct polarity positions.
- Use only batteries of the same or equivalent type as specified
- Never mix old and new batteries. Replace all batteries at the same time.
- Do not mix alkaline, standard and rechargeable batteries together in the battery compartment. Use only one battery type.
- Do not use rechargeable batteries in this product.
- Do not attempt to recharge non-rechargeable batteries.
- Promptly remove used batteries from the product.
- Remove batteries from the product before extended storage or product disposal.
- Do not dispose of batteries in fire; batteries may explode or leak.
- To prevent short-circuit of battery terminals, keep battery compartment free of all materials except batteries.
- Do not throw batteries in household garbage; dispose of them at battery collection stations or special garbage sites.
BATTERY INSTALLATION
- Remove the safety screw from the battery compartment cover and make sure
the positive (+) and negative (-) poles are in the correct position as shown in the diagram.
- Put the battery compartment cover back and fasten the cover by the safety screw.
Batteries are included for demonstration purpose only and may need
to be replaced by consumer.
BATTERY DIAGRAM:
USE 2 x 1.5V “AA” BATTERIES (NOT INCLUDED)
1.5V “AA”
1.5V “AA”
This device complies with Part 15 of the FCC Rules. Operation is
subject to following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FCC ID: 000000000000 / 2.4GHz
STOP
DRIFTING
148mm
210mm
IM
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: ( 1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment complies with the FCC radiation exposure limits set forth for an
uncontrolled environment, This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
The device can be used in portable exposure conditions without restriction.
