Instructions of Remote Control
1. Please pull out the insulation tape from the remote control,before starting to use it.
2. Press the button to select functions.The functions are :
ON : turn on the lights
OFF : turn off the lights
Steady on W : steady warm white
Steady on M : steady multicolor
Slow Glow : slow fading warm white & multicolor
Twinkle W : twinkle / flash warm white
Twinkle M : twinkle / flash multicolor
Slow Fade W : fading warm white
Slow Fade M : fading multicolor
Demo: all functions cycle
Instructions of foot pedal swtich control
Press RUSH button , select lighting functions below cycle.
Function 1: steady warm white
Function 2: steady multicolor
Function 3: slow fading warm white & multicolor
Function 4: twinkle / flash warm white
Function 5: twinkle / flash multicolor
Function 6: fading warm white
Function 7: fading multicolor off
Function 8: all functions cycle
Function 9: off
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
