Install
Example to install LTE module
Diagram
Step1:
1. Remove the Clip
Step2
2. Install the Clip, LTE module,
and long screws onto the
original Clip position of the
Helix according to the diagram.
Step3
3. install LTE Module ready
Active
Preparation
SSRT
You need to get SSRT account from Honeywell and add the centra Hub to your account, so
after device connects with centra hub, you can see the real time data at SSRT.
SIM Card
You need to buy a SIM card from operator, which needs support 4G network and activate
data traffic. And at the same time, inquire with the operator about the available APN for the
SIM card.
Module Install Check
Enter reading UI, check whether show “LTE” icon.
Configuration
PC software/DC app to configurate server IP, port and APN. (PC software and DC app not
ready)
Real time data
⚫ Wait a few minutes, check the color of Lora icon to see whether it change
⚫ Check the real time data at SSRT.
Warnings:
FCC CAUTION:
This device complies with part 15 of the FCC Rules. Operaon is subject to the following two
condions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operaon.
Any changes or modicaons not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment, this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
ISED WARNING:
This device complies with Innovaon, Science and Economic Development Canada
licence-exempt RSS standard(s). Operaon is subject to the following two condions: (1) this
device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operaon of the device.
Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitaonestautorisée aux deux condions suivantes : (1) l'appareil
ne doit pas produire de brouillage, et (2) l'ulisateur de l'appareildoit accepter tout
brouillageradioélectriquesubi, mêmesi le brouillageest suscepble d'encompromere le
fonconnement.
This Class A digital apparatus complies with Canadian ICES-003.
Cetappareilnumérique de la classe A estconformeà la norme NMB-003 du Canada.
Les communicaons eectuées au moyen de cetappareil ne sont pas nécessairement
protégées des indiscréons.
The equipment complies with ISED radiation exposure limits set forth for an uncontrolled
environment, this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Déclaraond'exposion aux radiaons:
Cetéquipementestconforme aux limitesd'exposion aux rayonnements ISED Canada établies
pour unenvironnement non contrôlé.
