USER MANUAL/用户手册
For DJI OSMO ACTION 6
Remote Control Street
Photography Kit (for
Action6)
遥控街拍套装
封面
Contents
目录
中文
EN
1
7
目录
④ ⑤
⑥
②
③
①
产品硬件介绍
⑧
⑦
①
②
③
④
⑤
⑥
⑦
⑧
状态指示灯
挂绳孔
拍照/录像键
开/关机键
开合按键
模式切换波轮
1/4螺纹接口
Type-C充电接口
1
⑨
⑩
⑪
⑫
⑬
⑭
⑮
侧盖开合按键
金属开关按键
冷靴接口
挂绳杆
挂绳孔
For Action6快拆口
⑨ ⑩ ⑪ ⑫ ⑭
⑭
⑮
⑬
1/4螺纹接口
(含2个阿莱定位孔)
2
街拍套装安装步骤
1.先将运动相
机装入兔笼
左仓
2.再将街拍手
柄与兔笼左
仓底部连接
3.向左合上街
拍手柄即可
完成安装
3
蓝牙街拍手柄使用教程
❶
❶
❷
❷
❸
❸
长按2秒开机，开机后进入蓝牙搜索状态，蓝
灯闪烁，与Action6连接后蓝灯常亮
单击可拍照/录像
左右滚动波轮可进行模式切换；按压波轮可拍
照/录像
4
兔笼安装步骤
1.先将运动相
机装入兔笼
左仓
2.再将兔笼侧
盖与兔笼左
仓底部连接
3.向左合上兔
笼侧盖即可
完成安装
5
产品清单
金属兔笼 标配
标配
标配
1
1
1
标配 1
塑料手柄
手腕绳
硅胶镜头盖
装上后可尽量
避免街拍套装
意外掉落
保护ACTION6
镜头
数量
规格说明
名称
配置
图示
适配 DJI OSMO
ACTION 6机型
免责声明
请仔细阅读本声明，一旦使用本产品，即视为对本声明的全部认
可和接受。每次使用前，请仔细检查产品，若出现破损、变形,请
勿使用。使用本产品，就意味着您认可并同意，您将对使用本产
品的行为和可能产生的后果负全部责任。您承诺仅会出于正当
合法的目的使用本产品。您理解并同意，对于直接或间接因使用
本产品而造成的滥用、不利影响、损害、伤害、惩罚或者其他法
律后果，泰迅数码有限公司（以下简称“Telesin”）将不承担任何
责任。用户应遵循包括但不限于本文提及的使用注意事项。在国
家法律法规范围内，本承诺解释权、修改权归Telesin所有。泰迅
保修期从您收到货物后的当日起计算，享有6个月保修服务。
/
6
④ ⑤
⑥
②
③
①
产品硬件介绍
⑧
⑦
①
②
③
④
⑤
⑥
⑦
⑧
Status Indicator Light
Lanyard Hole
Photo/Record Button
Power On/O Button
Opening & Closing Button
Mode Toggle Dial
1/4" Threaded Mount
Type-C Charging Po
7
⑨
⑩
⑪
⑫
⑬
⑭
⑮
Side Cover Latch Button
Metal Switch Button
Cold Shoe Mount
Lanyard Bar
anyard Hole
⑨ ⑩ ⑪ ⑫ ⑭
⑭
⑮
⑬
1/4" Threaded Inteace
(with 2 positioning holes for Arca plate)
Quick Release
Cutout for Action6
8
Street Shooting Kit
Installation Steps
1.Inse the
action camera
into the left
compament
of the cage.
2.Connect the
street shooting
grip to the
bottom of the
cage’s left
compament.
3.Slide the street
shooting grip
leftward to
complete
installation.
9
Bluetooth Street Shooting
Grip Operation Guide
❶
❶
❷
❷
❸
❸
Press and hold for 2 seconds to power on; the
unit enters Bluetooth pairing mode with blue
light ashing. The blue light stays solid after
successful connection with Action6.
Single press to take photos / sta recording.
Scroll the dial left/right to switch shooting
modes; press down the dial to take photos /
sta recording.
10
Cage Installation Steps
1.Inse the
action camera
into the left
compament
of the cage.
2.Attach the cage
side cover to
the bottom of
the cage’s left
compament.
3.Slide the cage
side cover
leftward to lock
and nish
installation.
11
Product Packing List
Metal Camera
Cage
Std. Acc.
Std. Acc.
Std. Acc.
1
1
1
Std. Acc.
1
Plastic Grip
Wrist Strap
Silicone Lens
Cap
Anti-drop
wrist lanyard
for street
shooting kit
Protect
ACTION6
Lens
Qty.
Spec.
Name
Cong.
Fig.
Custom frame
for DJI OSMO
ACTION 6
/
FCC Caution
15.19 Labelling requirements.
This device complies with pa 15 of the
FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful inteerence, and (2) this device
must accept any inteerence received, including inteerence that
may cause undesired operation.
15.21 Information to user.
Any changes or modications not expressly approved by the
payresponsible for compliance could void the user's authority to
operate the equipment.
15.105 Information to the user.
Note: This equipment has been tested and found to comply with the
12
limitsfor a Class B digital device, pursuant to pa 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful inteerence in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful inteerence to radio communications. However, there is no
guarantee that inteerence will not occur in a paicular installation. If
this equipment does cause harnnful inteerence to radio or television
reception, which can be determined by turning the equipment o
and on, the user is encouraged to t to correct the inteerence by
one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure
requirement. The device can be used in poable exposure condition
without restriction.
IC Statement
-English:
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the following
two conditions:
(1) This device may not cause inteerence.
(2) This device must accept any inteerence, including inteerence
that may cause undesired operation of the device.
Any changes or modications not expressly approved by the pay
responsible for compliance could void the user's authority to operate
the equipment.
RF exposure statement:
The device was evaluated to meet general RF exposure requirements.
The device can be used in poable exposure condition without
13
Disclaimer
Please read this disclaimer carefully. By using this product,
you acknowledge full acceptance of all terms herein.
Inspect the product for damage or deformation before
each use. Using the product signies your agreement that
you bear full legal liability for all conduct and
consequences arising from product use. You fully
understand and agree that the manufacturer shall not be
held liable for any adverse outcomes, damage or losses
caused by improper use or misuse of this product. Users
shall abide by all applicable laws and the usage guidelines
stated herein. Within the scope of relevant national laws,
we resee the right to interpret, revise and adjust all terms
of this warranty policy. The warranty period commences on
the date you receive the goods and covers 6 months of
customer seice suppo.
restriction.
- French:
Cet appareil contient des émetteurs / récepteurs exemptés de licence
conformes aux RSS (RSS) d'Innovation, Sciences et Développement
économique Canada. Le fonctionnement est soumis aux deux
conditions suivantes:
(1) Cet appareil ne doit pas causer d'inteérences.
(2) Cet appareil doit accepter toutes les inteérences, y compris celles
susceptibles de provoquer un fonctionnement indésirable de
l'appareil.
Tout changement ou modication non expressément approuvé par la
paie responsable de la conformité pourrait annuler l'autorité de
l'utilisateur à utiliser l'équipement.
Déclaration d'exposition RF:
L’appareil a été évalué pour répondre aux exigences générales en
matière d’exposition aux RF. L’appareil peut être utilisé en condition
d’exposition poable sans restriction.
14
Hereby, [Shenzhen Telesin Digital Co., Ltd.] declares
that the radio equipment type [TSFMS50-01] is in
compliance with Directive 2014/53/EU.The fulltext of
the EU declaration of conformity is available at the
following internet address：https://qr61.cn/oGcW-
jf/qsB4JQh
Hiermit erklä die [Shenzhen Telesin Digital Co.,
Ltd.], dass der Funkanlagentyp [TSFMS50-01] der
Richtlinie 2014/53/EU entspricht. Der vollständige
Text der EU-Konformitätserklärung ist unter der
folgenden Internetadresse veügbar:
https://qr61.cn/oGcWjf/qsB4JQh
Con la presente, [Shenzhen Telesin Digital Co., Ltd.] dichiara che il tipo di
apparecchiatura radio [TSFMS50-01] è conforme alla direttiva 2014/53/UE. Il testo
completo della dichiarazione di conformità UE è disponibile al seguente indirizzo
Internet: https://qr61.cn/oGcWjf/qsB4JQh
Par la présente, [Shenzhen Telesin Digital Co., Ltd.] déclare que le type d'équipement
radio [TSFMS50-01] est conforme à la directive 2014/53/UE. Le texte complet de la
déclaration de conformité de l'UE est disponible à l'adresse Internet suivante :
https://qr61.cn/oGcWjf/qsB4JQh
Por la presente, [Shenzhen Telesin Digital Co., Ltd.] declara que el tipo de equipo
radioeléctrico [TSFMS50-01] cumple con la Directiva 2014/53/UE. El texto completo
de la declaración de conformidad de la UE está disponible en la siguiente dirección de
Internet: https://qr61.cn/oGcWjf/qsB4JQh
Hermed erklærer [Shenzhen Telesin Digital Co., Ltd.], at radioudstyrstypen
[TSFMS50-01] er i overensstemmelse med direktiv 2014/53/EU. Hele teksten for
EU-overensstemmelseserklæringen ndes på følgende internetadresse:
https://qr61.cn/oGcWjf/qsB4JQh
Härmed försäkrar [Shenzhen Telesin Digital Co., Ltd.] att radioutrustningstypen
[TSFMS50-01] överensstämmer med direktiv 2014/53/EU. Hela texten till
EU-försäkran om överensstämmelse nns på följande webbadress:
https://qr61.cn/oGcWjf/qsB4JQh
Společnost [Shenzhen Telesin Digital Co., Ltd.] tímto prohlašuje, že typ rádiového
zařízení [TSFMS50-01] je v souladu se směrnicí 2014/53/EU. Úplné znění prohlášení o
shodě EU je k dispozici na následující internetové adrese: https://qr61.cn/oGcWjf/qsB4-
JQh
15
