MODEL:CTM302D05G1
nstruction Manual
Touch Control
Ceramic Hob
3
Installation
I
nstallation
2
CTM302D05G1
T
ouch Control
Ceramic Hob
4
GB IE
Let's
get started ...
Getting started...
05
Safety
06
In more detail...
10
11
12
1
17
18
19
Appendix
2
Installation
Before
you start
09
Product functions
Operation
Care and maintenance
Troubleshooting
Recycling and disposal
Technical and legal information
5
Getting
Started ...
gnitteG ...detrats
GB IE
Before you start
09
Safety
06
6
gnitteG ...detrats
GB IE
Safety
• All installation work must be carried out by
a competent person or qualified electrician.
• This appliance must be installed correctly
by a suitably qualified person, strictly
following the manufacturer’s instructions.
These instructions are for your safety. Please read
through them thoroughly prior to installation and retain
them for future reference.
This appliance complies with all current European safety
legislation however the Manufacturer must emphasise, ,
that this compliance does not prevent the surfaces of
the appliance from heating up during use and remaining
hot during its operation.
Accessible parts may become hot during use Young.
children should be kept away Care should e taken to. b
avoid touching the appliance e g hob ooker( . , ).c
The Manufacturer highly recommends that this appliance
be kept out of the reach of babies and mall children.s
Children should be supervised to ensure that they do
not play with the appliance.
Means for isolating the appliance must be incorporated
in the fixed wiring in accordance with he current wiringt
regulations An all pole disconnection he current wiring. - t
regulations An all pole disconnection witch having a. - s
contact eparation of at least 3 mm in all poles should bes
connected in fixed wiring.
Damaged power cables should be replaced by a ompetent
person or qualified electrician.
...detrats gnitteG
7
Safety
Make sure that the power cord is not caught under or in
the appliance and avoid damage to the power cable.
Do not allow the electric cables to touch the hot parts of
the appliance.
Do not install the appliance outdoors in a damp place or
in an area which may be prone to water eaks such asl
under or near a sink unit In the vent of a water leak. e
allow the machine to dry aturally.n
Please dispose of the packing material carefully.
Do not use flammable sprays in close vicinity to the
appliance.
We also recommend that great care be taken during use
and cleaning Read the cleaning and aintenance. m
sections for this appliance carefully.
A steam cleaner is not to be used.
The appliance is not intended to be operated by means
of external timer or separated remote control ystem- .s
The appliance is for domestic use only.
, eht emit gnol a rof no neeb sah enoz gnikooc a nehW
surface remains hot for some time afterwards o do nots
touch the ceramic surface.
Do not store detergents or flammable materials eneathb
the hob.
Do not leave hot oils or fats unattended as they aym
catch light.
gnitteG ...detrats
8
Safety
The Manufacturer declines all liability for personal or
material damage as a result of misuse or incorrect
installation of this appliance.
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
WARNING: The appliance and its accessible parts
become hot during use.Care should be taken to avoid
touching heating elements. Children less than 8 years of
age shall be kept away unless continuously supervised.
WARNING: Unattended cooking on a hob with fat or oil
can be dangerous and may result in fire.
NEVER try to extinguish a fire with water, but switch off
the appliance and then cover flame e.g. with a lid or a
fire blanket.
WARNING: Danger of fire: do not store items on the
cooking surfaces.
WARNING: If the surface is cracked, switch off the
appliance to avoid the possibility of electric shock.
WARNING: Use only hob guards designed by the
manufacturer of the cooking appliance or indicated by
the manufacturer of the appliance in the instructions for
use as suitable or hob guards incorporated in the
appliance. The use of inappropriate guards can cause
accidents.
This appliance is designed for domestic use only
.
The manufacturer shall not in any way be held
responsiblefor whatever injuries or damages are
caused by incorrect installation r by unsuitable oro
incorrect use!
9
...detrats gnitteG
Before you start
To avoid the risks that are always present when you use
an electrical appliance it is important that this appliance is
installed correctly and that you read the safety instructions
carefully to avoid misuse and hazards. Please keep this
instruction booklet for future reference and pass it on to any
future owners. After unpacking the appliance please check
that it is not damaged. If in doubt, do not use the appliance.
Check the package and make sure you have all of the
parts listed.
Decide on the appropriate location for your product.
If this product contains glass please take care when fitting
or handling to prevent personal injury or damage to the
product.
The specifications plate is
on this appliance.located the base of
This plate displays all the necessary identification information for
ordering replacement parts.
If you sell the appliance, give it away, or leave it behind
when you move house, make sure you also pass on this
manual so that the new owner can become familiar with the
appliance and its safety warnings.
Before you start
Tools required
SILICONE
and contact the after sales service department.
10
nI erom ...liated
Product functions
11
Operation 12
Care and maintenance 15
Troubleshooting 17
Recycling and disposal 18
Technical and legal information 19
more
d
etail...
In
12
Operation
DescriptionRecnerefe
Zone position
Power regulating key (reduce)
Power regulating key (increase)
ON / OFF
A
B
C
D
In more detail...
Operation
The following shows how to reduce total environmental impact
(e.g. energy use)of the cooking process).
1. Use suitable size of pan for cooking.
2. Cover the pan with lid if possible during cooking.
3. Choose pan which has better retaining heat capacity.
4. If possible, defrost frozen food in a way which does not
need any power consumption.
5. It takes less time to cook food which has large surface
area to volume ratio.
E
F
Child lock key
Timer key
Heating Zone Max.Power ( 230V~)
00 W81
1200 W
,then from 0-9 in numberical order
120
120
15
Warning
Always switch off the electricity supply before
performing maintenance work. In the event of a fault,
contact customer services.
OFF
Care and maintenance
Care
Damaged power cables should be replaced by a
competent person or qualified electrician.
For domestic use only.
Never place an empty pan on the hob as this will cause
the over heat protection, then the appliance will switches
off automatically.
When a cooking zone has been on for a long time, the
surface remains hot for some time afterwards so do not
touch the ceramic surface.
For sealed foods, please do not heat them before
opening removing the lid so as to avoid any dangers of
explosion due to heating expansion.
If the surface of the hob is cracked, disconnect the hob
from power supply to avoid any possibility of electricthe
Do not place rough or uneven pans on the hob, as they
could damage the ceramic surface.
nI ...liated erom
Care and maintenance
shocks.
16
Avoid banging pots and pans down on the hob.
The ceramic surface is tough but not unbreakable.
Do not put detergents or flammable materials beneath
the hob.
Care and maintenance
Appliance cleanliness
>The appliance should be cleaned after use.
>The surface of the ceramic hob may be easily cleaned in the following
way:
Type of dirt Cleaning method Cleaning materials
Limescale Apply white vinegar to the
surface, then wipe it dry
with soft cloth
Special ceramic cleaner
Burnt-on stains Clean with damp cloth and
dry it with a soft cloth
Special ceramic cleaner
Light stains Clean with damp cloth and
dry it with a soft cloth
Cleaning sponge
Melted plastics Use a scraper suitable for
ceramic glass to remove
residue
Special ceramic cleaner
Caution
• Avoid rubbing with any abrasive or with the base
of the pans, etc, as this will wear the markings on
the top of the ceramic hob over time.
• Clean the ceramic hob on a regular basis to
prevent the build up of food residue.
nI ...liatederom
Care and maintenance
E4 circuit open
F4 high temperature
Please check which heating zone show
"E4",then replace the thermocouple of
the heating zone.If still show "E4",please
replace the display board or contact
supplier
Please check which heating zone show
"F4",then replace the thermocouple of
the heating zone.If still show "F4",please
replace the display board or contact
supplier
Environmental Protection
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
retailer for recycling advice.
The symbol on the product or its packaging indicates that this
product cannot be treated as normal household waste. This product
must be handed over to an electric and electronic equipment
collection point for recycling.
On ensuring that this product is disposed of correctly, you will help to
avoid possible negative consequences for the environment and public
health, which could occur if this product is not handled correctly. To receive
more detailed information about recycling this product, contact your local
government, domestic waste disposal services or the outlet where the
product was bought.
Do not dismantle the appliance in a way which is not shown in the
user manual.The appliance could not be dismantled by user. At the
end of life, the appliance should not be disposed of with household
waste. Check with you Local Authority or retainer for recycling
advice.
Information for dismantling
Before calling the customer services, please check that the appliance is
correctly connected, any of the following cases are not covered by the
guarantee
> Damage caused by improper use, storage or maintenance
> Damage caused by unauthorised disassembly and repair.
> Damage caused by misuse.
> Using the ceramic hob for commercial purposes.
18
Recycling and Disposal
eromnI ...liated
19
All installation work must be carried out by a
competent person or qualified electrician.
Before connecting the mains supply ensure that
the mains voltage corresponds to the voltage on
the rating plate inside the cooker hood.
W
arning: THIS APPLIANCE MUST
BE EARTHED.
D
irect Connection
If the appliance is being connected directly to the mains an
omnipolar circuit-breaker must be installed with a minimum
opening of 3mm between contacts.
If the cable is damaged or to be replaced, the operation must be
carried out the by a qualified electrician with dedicated tools to
avoid any accidents.
The installer must ensure that the correct electrical connection has
been made and that it complies with wiring diagram.
The cable must not be bent or compressed.
The cable must be checked regularly and replaced by authorized
technicians only.
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
USE A 3AMP FUSE
FUS
E
USE A AMP FUSE16
Technical and legal
information
nI ...liatederom
ON
20
Technical and legal
information
Electrical Requirements
Any permanent electrical installation must comply with the latest
I.E.E. Regulations and local electricity company regulations. For
your own safety a qualified electrician or contractor who is on the
roll of the National Inspection Council for Electrical Installation
Contracting (NICEIC) should undertake the electrical installation.
Electrical Connection
Before connecting the mains supply ensure that the mains
voltage corresponds to the voltage on the rating plate inside
the appliance.
WARNING: THIS APPLIANCE MUST BE EARTHED
The appliance is supplied with a 3-core mains cable and must be
connected to the electricity supply via a double pole switch having
a 3mm minimum contact gap on each connector.
The wires in the mains lead are coloured in accordance with the
following code:
Brown = L - Live
Blue = N - Neutral
Green/Yellow = Earth
The connection point must be placed in a position adjacent to the
appliance so as to be readily accessible for an engineer in the
event of a breakdown.
Disconnect the appliance from the mains supply before
carrying out any kind of maintenance or cleaning.
nI ...liatederom
Installation
Appendix ...
...xidneppA
21
Installation
Hob installation
> Cut a hole in the worktop of the size shown in the diagram.
The worktop
should be at least 30 mm thick and made of a heat-resistant material.
Seal cut edge of the worktop with silicone or PVA.
Electrical connection
Caution
The ceramic hob must be installed by a
suitably qualified person. Never try to install
the appliance yourself. The ceramic hob must
not be installed above refrigerators, freezers,
washing machines or tumble dryers. The wall
and the area above the hob should be able to
withstand heat.
Caution
• The cord should not be extended or folded
into coil during operation.
• Adapters, multi-socket strips and
extension leads must not be used.
• Overloading could result in a risk of fire.
Caution
Before connecting to the power supply, check:
• The voltage meets requirements.
• The appliance uses an individual socket and
does not share one with another electric
appliance. A dedicated power protection
switch must be incorporated in the fixed
wiring in accordance with the wiring rules.
...xidneppA
22
650mm
At least
150mm
750mm
55mm
At least
150mm
Installation
Clearance
...xidneppA
Warning
Good ventilation is required around the appliance for easier
dissipation of heat and low power consumption.
Sufficient clearance is required around the appliance.
The gap between the hob and any cupboard above it
should be at least
dellatsni eb ot si dooh rekooc a fI7 .mm05
above the hob please consult the hood instruction manual
for this minimum distance.
23
270 490
490
270
25
A B C D
screw br ack et
S
crew hole base
01
Notes
27
