FCC compliance information statement
Product Name: AXE5400 Tri-Band Wi-Fi 6E High Gain Wireless USB Adapter
Model Number: Archer TXE70U Plus
Responsible Party:
TP-Link Systems Inc.
Address: 10 Mauchly, Irvine, CA 92618
Website: http://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6804
E-mail: sales.usa@tp-link.com
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
FCC RF Radiation Exposure StatementThis equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter. This equipment has been
SAR-evaluated for use in hand. SAR measurements are based on a 5mm spacing from the
body and that compliance is achieved at that distance.
FCC regulations restrict the operation of this device to indoor use only.
Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or
communications with unmanned aircraft systems.
We, TP-Link Systems Inc., has determined that the equipment shown as above has been
shown to comply with the applicable technical standards, FCC part 15. There is no
unauthorized change is made in the equipment and the equipment is properly maintained
and operated.
Issue Date: 2025-09-15
Canadian Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to
the following two conditions:
(1) This device may not cause interference.
(2)
T
his device must accept any interference, including interference that may cause undesired
operation of the device.
• Devices shall not be used on automobiles.
• Devices shall not be used on trains.
• Devices shall not be used on maritime vessels.
• Devices shall not be used for control of or communica�ons with unmanned aircra�
systems.
• Devices shall not be used on oil pla�orms.
• Devices shall not be used on aircra�, except for the low-power indoor access points,
indoor subordinate devices, low-power client devices, and very low-power devices
opera�ng in the 5925-6425 MHz band, that may be used on large aircra� as defined
in the Canadian Avia�on Regula�ons, while flying above 3,048 metres (10,000 feet).
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2)
L
’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
• Les dispositifs ne doivent pas être utilisés pour commander des systèmes d'aéronef
sans pilote ni pour communiquer avec de tels systèmes;
• Les dispositifs ne doivent pas être utilisés sur les plateformes de forage pétrolier;
• Les dispositifs ne doivent pas être utilisés dans les aéronefs, à l'exception des points
d'accès intérieurs de faible puissance, des dispositifs subordonnés intérieurs, des
dispositifs clients de faible puissance et des dispositifs de très faible puissance
fonctionnant dans la bande de 5 925 à 6 425 MHz, qui peuvent être utilisés dans les
gros aéronefs tel qu'il est défini dans le
Règlement de l'aviation canadien
, et ce,
lorsqu'ils volent à une altitude supérieure à 3 048 mètres (10 000 pieds).
• Les disposi�fs ne doivent pas être u�lisés dans les automobiles;
• Les disposi�fs ne doivent pas être u�lisés dans les trains;
• Les disposi�fs ne doivent pas être u�lisés sur les navires mari�mes.
Caution:
1） The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems;
DFS (Dynamic Frequency Selection) products that operate in the bands 5250- 5350 MHz,
5470-5725MHz.
Avertissement:
1） Le dispositif fonctionnant dans la bande 5150-5250 MHz est réservé uniquement pour
une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux
systèmes de satellites mobiles utilisant les mêmes canaux;
Les produits utilisant la technique d'atténuation DFS (sélection dynamique des fréquences)
sur les bandes 5250- 5350 MHz, 5470-5725MHz.
D
evices shall not be used for control of or communications with unmanned aircraft
systems.
Les appareils ne doivent pas être utilisés pour le contrôle ou la communication avec
des systèmes d'aéronefs sans pilote.
Radiation Exposure Statement:
This EUT is compliance with SAR for general population/uncontrolled exposure limits in
RSS-102 and had been tested in accordance with the measurement methods and
procedures specified in IEEE 1528 and IEC 62209. This equipment should be installed and
operated with minimum distance 0.5 cm between the radiator and your body. This device
and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
Déclaration d'exposition aux radiations :
Cet adaptateur est conforme au SAR pour la population générale/limites d'exposition
non contrôlées dans RSS-102 et a été testé conformément aux méthodes et procédures
de mesure spécifiées dans IEEE 1528 et CEI 62209. Cet équipement doit être installé et
utilisé avec une distance minimale de 5 mm entre le radiateur et votre corps. Cet appareil
et ses antennes ne doivent pas être situés ou fonctionner en conjonction avec une autre
antenne ou un autre émetteur.
C
E Mark Warning
OPERATING FREQUENCY (the maximum transmitted power)
2400 MHz -2483.5 MHz (20dBm)
5150 MHz -5250 MHz (23dBm)
5250 MHz -5350 MHz (23dBm)
5470 MHz -5725 MHz (23dBm)
5945MHz -6425 MHz (23dBm)
EU Declaration of Conformity
TP-Link hereby declares that the BE6500 Tri Band Wi-Fi 7 Mini Wireless USB Adapter is in
compliance with the essential requirements and other relevant provisions of directives
2014/53/EU, 2011/65/EU and (EU)2015/863.
The original EU Declaration of Conformity may be found at https://www.tp-
link.com/en/support/ce/.
RF Exposure Information
This device meets the EU requirements (2014/53/EU Article 3.1a) on the limitation of exposure
of the general public to electromagnetic fields by way of health protection.
This device has been tested and meets the ICNIRP exposure guidelines and the European
Standard EN 62209-2. SAR is measured with this device at a separation of 5 mm to the body,
while transmitting at the highest certified output power level in all frequency bands of this
device. Carry this device at least 0.5 cm away from your body to ensure exposure levels remain
at or below the as-tested levels.
National Restrictions
Frequency band: 5150 - 5250 MHz:
Indoor use: Inside buildings only. Installations and use inside road vehicles and train carriages
are not permitted. Limited outdoor use: If used outdoors, equipment shall not be attached to
a fixed installation or to the external body of road vehicles, a fixed infrastructure or a fixed
outdoor antenna. Use by unmanned aircraft systems (UAS) is limited to within the 5170 -
5250 MHz band.
Frequency band: 5250 - 5350 MHz:
Indoor use: Inside buildings only. Installations and use in road vehicles, trains and aircraft are
not permitted. Outdoor use is not permitted.
Frequency band: 5470 - 5725 MHz:
Installations and use in road vehicles, trains and aircraft and use for unmanned aircraft systems
(UAS) are not permitted.
Frequency band 5945 -6425MHz:
Restricted to indoor use, including in trains with metal-coated windows and aircraft. Outdoor
use, including in road vehicles, is not permitted
UKCA Mark
U
K Declaration of Conformity
TP-Link hereby declares that the BE6500 Tri Band Wi-Fi 7 Mini Wireless USB Adapter is in
compliance with the essential requirements and other relevant provisions of the Radio
Equipment Regulations 2017.
The original UK Declaration of Conformity may be found at https://www.tp-
link.com/support/ukca/.
Attention: This device may only be used indoors in Great Britain.
I
ndustry Canada Statement
CAN ICES-003 (B)/NMB-003(B)
Korea Warning Statements:
당해 무선설비는 운용중 전파혼신 가능성이 있음.
Продукт сертифицировано згідно с правилами системи УкрСЕПРО на відповідність
вимогам нормативних>Продукт сертифіковано згідно с правилами системи УкрСЕП
РО на відповідність вимогам нормативних документів та вимогам, що передбачені
чинними законодавчими актами Украıни.
この製品は屋内においてのみ使用可能です。
NCC Notice & BSMI Notice
注意！
取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更頻率、加
大功率或變更原設計之特性及功能。
低功率射頻器材之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停
用，並改善至無干擾時方得繼續使用。
前述合法通信，指依電信管理法規定作業之無線電通信。
應避免影響附近雷達系統之操作。
低功率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
安全諮詢及注意事項
請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。
清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。
注意防潮，請勿將水或其他液體潑灑到本產品上。
插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。
請勿將本產品置放於靠近熱源的地方。除非有正常的通風，否則不可放在密閉位置中。
不要私自拆開機殼或自行維修，如產品有故障請與原廠或代理商聯繫。
