GLS-005 LoRaWAN Water MIU
USER’S GUIDE
Version 1.0 Draft
NOTICES
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following
two condions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operaon.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protecon
against harmful interference in a residenal installaon. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the
instrucons, may cause harmful interference to radio communicaons. However, there is no
guarantee that interference will not occur in a parcular installaon. If this equipment does
cause harmful interference to radio or television recepon, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Equipment that this document is applicable to will be labeled in a visible area with FCC ID:
Y8E-GLS005
CAUTION: Any changes or modicaons not expressly approved by Vision Metering LLC could
void the user's authority to operate this equipment.
This equipment complies with FCC radiaon exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated at a minimum distance of
0cm between the radiator and a person’s body. Avoid alternatve operatng confguraons.
Installaon
The GLS-005 is a sealed, poed device with integral antennas. There are no user-serviceable
parts, and the antennas cannot be replaced or modied.
Install the device in its intended meter pit, meter box, or wall-mount locaon. Maintain the 20
cm separaon distance specied above. Avoid surrounding the device with metal or other
conducve materials that would block RF transmission. Do not open, drill, or otherwise modify
the enclosure.
