Mudra Pro - Quick start Guide
Do not bend the silicone Do not bend the silicone
against its natural curve.against its natural curve.
Product name : Mudra Pro
Model : 1
Maximum output power : DC 3.8V 35mAh,
Wireless RF frequency band : 2402MHz~2480MHz
Manufacturer : Wearable Devices LTD
FCC Requirement
changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation. Note: This equipment has been tested
and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy, and if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures: – Reorient or relocate the receiving antenna. – Increase the
separation between the equipment and receiver. – Connect the equipment
into an outlet on a circuit different from that to which the receiver is
connected. – Consult the dealer or an experienced radio/TV technician for
help. This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that
may cause undesired operation of the device. L'émetteur/récepteur exempt
de licence contenu dans le présent appareil est conforme aux CNR d'Innovation,
Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :
1) L'appareil ne doit pas produire de brouillage;
2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement
For a full instructions and regulatory warnings please refer to the User
manual in the website: www.mudra-band.com/safety
Right Hand Placement: Right Hand Placement:
Position the Mudra-PPosition the Mudra-P0202 so so
the logo is at the top.the logo is at the top.
Le Hand Placement: Le Hand Placement:
Position the Mudra-PPosition the Mudra-P0202 so so
the logo is at the boom.the logo is at the boom.
ChargingCharging
DisconnectedDisconnected
DFUDFU
ConnectedConnected
AdvertisingAdvertising
Type C - charging port
PPG Sensor
Power Buon
SNC Electrodes (3 sets)
DRL Electrodes
LED
Press - turn onPress - turn on
Long press - turn offLong press - turn off
LED
Buon
