UEC Refresher
RSR-32 Product Spec
RF
Protocol
Bluetooth 4.2
RF Type
2.4GHz
Mechanical and Electrical
Dimension （Height X
Length X Width）
5.3 X 11.7 X 4.0 cm
Material
PC
Push Button
Function: When the internal button is pressed, it
detects if the Refresher LED light is lit, and if so, the
STATUS LED light also illuminates. If you don't do it
on time, it will return to power saving mode.
Power
CR-2450 3.0V Battery 620mAh
If the results are sent every five minutes, it is
expected to be useful for 2 years.
Operating
Environment
Working Temperature： -20∘C -60∘C
Working Humidity：10% - 90%RH
Operating Manual
1. First, remove the four screws on the top cover and remove the top cover
to expose the battery holder on the circuit board.
2. Remove the isolation tab of the CR2450 coin cell battery and it will work.
3. Please record the time when the battery started working and stick it on
the back of the cover for record.
4. Assembling Refresher Monitor to the Refresher before it is powered on
5. Press the button, and the STATUS LED will not light up because no light
source is detected.
6. When the Refresher machine is plugged in, the LED will glow when it is
working properly, and if the button is pressed at this time, the STATUS LED
will light up.
7. Close the top cover and lock the four screws.
8. Setup is complete.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment o` and on, the user is encouraged to try to
correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit di`erent from that to which
the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications
not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment. (Example - use only shielded
interface cables when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
The antennas used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause
undesired operation.
