Qasair Rangehoods Installation Instructions4
CONDARI PTY LTD makes over 120 different models of QASAIR Rangehoods plus
many special rangehoods designed by architects and interior designers.
It is important to follow the installation instructions.
There are many different cooking appliances on the Australian market today.
Examples: Electric Ego, ceramic hotplates, teppanyaki plates and Induction hotplates. There are gas hotplates
drawn out from the catchment area of the rangehood.
minimum should be 750mm.
.
way, as this may result in reduced performance.
IMPORTANT INFORMATION
Qasair Rangehoods Installation Instructions
5
by warranty.
gas or other fuels.
6. WARNING:
from burning gas or fuel;
b) For cleaning purposes please refer to
d) Some parts of the rangehood may become hot when cooking;
e) This appliance is not intended for use by persons (including children) with reduced physical, sensory or
or instruction concerning use of the appliance by a person responsible for their safety.
9. NOTE
for optimum results. Barbecues should be positioned under the centre of the hood where the fans are mounted
and not near the outer edges where leakage may occur.
only through single sheet material.
name.
Qasair Rangehoods Installation Instructions
33
INSTALLATION INSTRUCTIONS
• H SERIES
• PYR
3.
4.
5.
6.
7.
8. Fix mounting bracket to wall at desired height.
9.
the time to install fixing points. Four points are recommended with one on each side at top and one on each side
at bottom.
Check flue slides through hole in ceiling.
Carefully lift canopy into position, guiding flue through ceiling and feeding power cable through hole in rear of
canopy. Make sure canopy is sitting correctly on mounting bracket then fix to wall through fixing holes with solid
screws. (You may need to place a packer behind canopy if wall is bowed to make the canopy sit correctly).
turned off during work.
silicone). A plumber should seal roof penetration with appropriate flashing. All joins in ducting need to be sealed
Fit motor(s) back into canopy with fixing bolts and plug electrical connector in.
Test run hood.
MOUNTING BRACKET
•
• Before cutting any holes check ceiling space for structural beams. It may be possible at this point to relocate the
hood position.
The fixing points are prepunched holes in the back of the hood and it may be necessary to drill through the back
of the hood into the wall stud.
Installation must be carried out by the procedure outlined.
Failure to do so may void the guarantee.
Electrical: Wiring to the appliance must comply with State and local Regulations.
Connection to be carried out by a registered electrician.
Qasair Rangehoods Installation Instructions34
Heritage
Technical Specification Sheet
H
Wall Mounted
3
310mm
Power Entry Vertical
Light Centres
Light Qty
600mm
600HL-1
LED Light
Conversion
Top/Back Back/Top
Nightlight
2
Condari Pty Ltd.
Filter Qty
2
Motor Qty
Motor Box /
Flue Width
150mm
Version: C 20/01/2015F
Body Width
Model 600HL-1
Page 1 of 2
Filter Size
272mm
NO
700HL-1
Square Square
130mm
900HL-1
N/A
YES
125mm
Power Entry Horizontal
PowderKote
Available
Corner Type
Electrical Connection
YES
Outlet Spacing
900mm
240mm
Cool
11
700HL-1
Cool
510mm
22
310mm
YES
Junction Box
NO
Junction Box
135mm 210mm
NO
YES
Square
N/A N/A
272mm
290mm
150mm
Junction Box
Model900HL-1
YESYES
1
240mm
Cool
240mm
700mm
2
HERITAGE - H
Qasair Rangehoods Installation Instructions
35
Heritage
Technical Specification Sheet
H
Wall Mounted
YES
2
816mm
2
370mm
Cool
Model1500HL-2
1500mm1200mm
370mm
1200HL-2
YES
Cool
2
Power Entry Vertical
648mm
22
Cool
370mm
2
YES
5
Outlet Spacing
Model
Body Width
Motor Box /
Flue Width
Motor Qty
LED Light
4
1000HL-2
1000mm
510mm
3
Nightlight
Light Qty
Light Centres
Filter Qty
Junction Box
215mm
375mm
YES
272mm
272mm
1500HL-2
NO
1200HL-2
YES
150mm
Square
Version: C 20/01/2015F
Square
75mm
290mm
1000HL-2
Junction Box
130mm
100mm
NO
Square
Page 2 of 2
Junction Box
NO
250mm
YES
190mm
100mm
Condari Pty Ltd.
PowderKote
Available
Corner Type
Electrical Connection
Power Entry Horizontal
Filter Size
Conversion
Top/Back Back/Top
HERITAGE - H
Qasair Rangehoods Installation Instructions36
Pyramid
Technical Specification Sheet
PYR
Wall Mounted
Conversion
Top/Back Back/Top
Filter Size
Model
Electrical Connection
Minimum Height
(H =)
Maximum Height
(H =)
PowderKote
Available
All-thread
Fixing Centres
Page 1 of 1
Corner Type
N/A
Filter Qty
3
Motor Qty
Light Qty
Light Centres
Motor Box /
Flue Width
Body Width
Model
Cool
YES
2
PYR 900L-1
1
900mm
270mm
510mm
LED Light
Nightlight
Condari Pty Ltd.
Junction Box
PYR 900L-1
Square
Version: B 20/01/2015F
NO
N/A
N/A
N/A
272mm
PYRAMID - PYR
Qasair Rangehoods Installation Instructions
101
FILTER CLEANING
RANGEHOOD CLEANING
For the best results, please clean filters regularly. Condari recommends cleaning filters
You can do this by hand washing in warm soapy water, or by placing filters in the top rack
dishwasher may cause discolouration of the filters.
Ensure the filters are completely dry before placing them back. Do not operate the
rangehood without the filters installed.
Condari does not recommend the use of any citrus or industrial products, particularly
•
•
Stainless Steel cleaner may be used.
Qasair Rangehoods Installation Instructions102
CONDARI PTY LTD APPLIANCE GUARANTEE
The benefits conferred by this warranty are in addition to all other rights and remedies in
respect of the product which the consumer has under the Competition and Consumer Act
that the appliance will be free from defects in materials and workmanship for a period of 36
months from the date of purchase of the appliance to the consumer.
of the appliance to the customer.
This warranty is conditional upon the appliance being used only for personal, domestic and
household purposes and installed and operated in accordance with QASAIR Instructions and
does not apply to articles which by their nature are consumable.
If a defect is caused by neglect, misuse, or failure to follow operating instructions where
special precautions are detailed
call.
For example:
With the filters the user is specifically requested:
• To clean filter regularly by handwashing or placing in a dishwasher at least once a month.
• To turn rangehood off after each use.
Where a claim is made under warranty,
of parts from the unit or to their replacement. Amongst other things, such responsibility shall
extend to damaged walls, tiles, fixtures and fittings whether or not the unit has been built
Qasair Rangehoods Installation Instructions
103
EXCLUSIONS
outdoor use only and also a mega joule rating per burner or a total mega joule rating.
special hoods are required for the appliances.
situated in domestic kitchens.
Qasair Rangehoods Installation Instructions104
Date purchased
Purchased from
Model
original purchase document. This form must be produced if and when
a claim is made under this warranty.
QASAIR Rangehoods are made in Ringwood, Australia.
Email: [email protected]
STANDARD
WARRANTY
