IN SEC T KILLER
Use r Ma nua l
by
www.Pyle USA.c o m
PSLBZ22
User Manual
The Electronic Insect Killer utilizes the UV-A energy saving lamp of the wave
length, which is proven to be the most effective lure for light sensitive flying
insects, such as flies, moths, mosquitoes, and other flying insects. These insects
are electrocuted by the electrically-charged metal grids. No chemicals, no smell,
no sprays, no mess, pollution free and harmless to humans and pets. It is ideal for
indoor and outdoor use, such as houses, factories, food outlets, restaurant,
canteen, office, hospitals, garden, hallway, etc.
FEATURES:
1. IPX4 water-proof, outdoor and indoor use.
2. New design, both for night lamp/garden lamp and insect killer.
3. High efficiency UV tubes proven to be more effective and longer lasting than
standard UV tubes.
4. Innovative killing grid.
5. Robust construction.
WARNINGS:
1. High voltage! Disconnect power before repairing or cleaning.
2. Children cannot play with it.
3. Never put metal objects inside the grids while in operation.
4. Keep away from flammables.
5. Check the local voltage before operating.
6. Put on a place where children cannot reach.
7. If damaged, supply cords must be repaired or replaced by a qualified
technician.
8. The Insect Killer cannot be used in garage, stable or similar places.
9. Clean the collection tray regularly.
THE COMPULSORY CAUTIONS:
"This appliance is not intended for use by persons
(including children) with reduced physical, sensory or mental capabilities or lack
of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their
safety"
Tube replacement:
1. Remove the collection tray
2. Loosen the two screws and take away the lamp groove
3. Rotate the tube and replace
www.Pyle USA.c o m
TUBE INSTALLATION BEFORE USING
It will take two minutes to install tube before using the Insect Killer,
please check below pictures explanation.
Step 1:
Take away the bottom collection
Step2:
Loosen the two screws and take away
the lamp groove
Step3:
Put the lamp into the upper groove
and rotate clockwise
Step4:
Lid the lamp groove, tighten two
screws and close the collection tray
