BEVERAGE REFRIGERATOR
USER MANUAL
This appliance is intended to be used in household and similar applications.
Shop, office , or the kitchen of other worker area.
Farm, hotel, car hotel and the living environments of Customers.
Environments of the family hotel's type.
Catering and similar non-retail industry application.
Please read the following instructions carefully before using your refrigerator.
-Don’t put hot food inside the refrigerator.
-Wrap all food items with a plastic protection film to avoid dehydration and loose food flavor.
-Close immediately the refrigerator door after each usage.
-If you don’t use the refrigerator for a long period of time, disconnect the unit, clean the inside parts, put the refrigerator in a dry area
and leave the doors lightly open.
I. GENERAL
The refrigerator is extensively used in places such as hotels, offices, houses and student dormitories. It is mostly suitable for
refrigerating and conserving foods such as fruits and beverages. It enjoys the advantages of small size, light weight, high efficiency
and low energy consumption.
II. UNPACKING, REPACKING AND MOVING
1. Unpacking
Just cut off the packing band, and then pull the carton up.
2. Repacking
Please remember to put the original foamed pads in place.
3. Moving
Be sure refrigerator trays in upright positions during moving it
Don’t tilt it for more than 45 degree from upright position. Never upset it.
Don’t apply force on any external part such as pipe, condenser, door and it’s shelf moving refrigerator must be well packed and
secured in long distance transportation to avoid damage from impacting or great shocking.
III. INSTALLATION
The refrigerator should be placed on a flat and solid top surface. It should be kept away from sunlight, heat source, humid or met place.
The refrigerator should be kept away from the wall for a proper space for good.
Air circulation when the refrigerator is placed in a cupboard, the rear of the cupboard must be removed out, for good air circulation.
IV. OPERATION
1. Before the refrigerator is plugged in, check the following:
-There must not be any damage on all electric cords.
-Each screw must be well fixed
-Wall out let must be properly ear chen
Be sure that everything is in normal condition and the refrigerator can be plugged in.
2 .When operation for the first time
When operating for the first time, before loading food in, run the refrigerator without any load until it auto stops at the desired
temperature, usually it takes 2 or 3 hours. Then set the thermostat to the required setting and place foods in
3. Temperature control
Refrigerator’s temperature can be adjusted by turning the knob of the thermostat. The closer to “5” position the knob is set, the lower
the temperature becomes. A medium setting is the most suitable for general operation. Set the thermostat “5” position only when Ice
cubes are needed or frozen foods are stored in the freezing compartment.
Refrigerator’s temperature will vary depending on the quantity of foods stored and the frequency of the door opening. In order to
maintain good cooling efficiency and save energy, we recommend you not to store too much foods and not to open the door too
frequently.
CAUTION: When the thermostat has been turned clockwise to “5” position, don’t attempt to turn it moreover, otherwise, it will be
damaged.
4. Ice cubes making
After filling the ice tray with drinkable water till about 80% of its volume, put it into the freezing compartment and then set the
thermostat at “5”, it takes about 3 hours to make ice cubes.
V. DEFROSTING
Defrost the freezing compartment whenever the layer of frost. Ice on the evaporator reaches 3-4 mm. when defrosting remove out all
foods and ice cube trays. Put the drip tray in place to collect melted water to start defrosting, set the thermostat at “0” positions and
keep the door open. After the frost or ice has melted, discard the melted water and dry up the interior of the refrigerator. The
refrigerator can then be restarted by a turning its thermostat to the desired setting
CAUTION: never use any sharp of metallic instruments (e.g. knives) to remove frost or ice from the evaporator as this will damage
the evaporator, a puncture evapora will cause serious problems.
VI. CLEANING AND MAINTENANCE
1. To clear the refrigerator, disconnect power supply and removed foods, shelves, tray sets. Use a solution mixed with 2 spoons of
baking soda per litre of warm water to clean the interior. Then wipe it clean with fresh water.
Never use acids, chemical thinker, gasoline, benzene or the like for cleaning any part of the refrigerator. Never use boiling water and
benzene to clean plastic parts because they may deform or damage the plastic parts.
2. Too much foods stored or large container in the refrigerator will affect cold air circulation, so some free space must be left. It is
recommended that about 70% of storage volume is loaded.
Don’t store volatile and/or explosive materials such as others, gasoline liquefied petroleum gas, achieves etc. in the refrigerator.
Otherwise, there will be a danger of fire or explosion caused by electric sparks.
VII. SAFETY INSTRUCTIONS
Before plugging your refrigerator in, check that the electric supplying your house must comply with the rating(voltage, frequency) of
the refrigerator, the rating plate is usually on the back of the refrigerator.
The refrigerator should always be plugged in it’s, electrical out let to prevent overload, which could cause a possible fire hazards from
over heating wires, don’t splash water on the refrigerators as this will cause electrical leakage or failures. If the power cord becomes
damaged, ask one same specification to replace it immediately. The refrigerator must be proper earthed
Our corporations will be not responsible for any accident caused by improper ear or improper operation.
VIII. SPECIFICATIONS
MODEL
HLWK33T
HLWK65T
REFRIGERANT
R600a,
0.56Oz
R600a,
0.56Oz
INPUT POWER
65W
70W
RATED VOLTAGE
110-120V~
110-120V~
RATED FREQUENCY
60Hz
60Hz
TOTAL STORAGE
VOLUME
1.3 Cu.Ft.
2.3 Cu.Ft.
NET WEIGHT
26.4 lbs.
33.0 lbs.
Note: specifications subject to change without notice
Warning:
WARNING – Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
WARNING – Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by
the manufacturer.
WARNING – Do not damage the refrigerant circuit.
WARNING – Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type
recommended by the manufacturer.
Do not use electrical applicances inside the food storage compartments of the appliance, unless they are of the type recommended
by the manufacturer.
The refrigerant and insulation blowing gas used in the appliance require special disposal procedures. At disposal, please consult
with service agent or similarly qualified person.
Do not use mechanical devices or the means to accelerate the defrosting process other then those recommended by the
manufacturer. Don’t damage the refrigerant circuit.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
If Incandescent light does not shine, Cut power, then take off light cover by against the grain and take off the lamp by counter-cw
and put new lamp by cw.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.
As R600a and ensure that the use of R600a refrigerant products If the refrigerator for cooling systems in need of repair, we must
find a point person to the designated repair maintenance. No demolition\transformation without refrigerators, refrigeration piping is
prohibited.
As R600a flammable, and forbids any acts can lead to leakage of refrigerant.
