BEVERAGE COOLER
JC-708(/)
1
English
GENERAL SAFETY RULES
Before you use your refrigerator, please read this owner’s manual carefully.
Use this appliance only for its intended purpose as described in this owner’s manual.
DANGER : Risk of child entrapment. Before you throw away your old refrigerator or freezer:
Take off the doors.
Leave the shelves in place so that children may not easily climb inside.
The appliance must be correctly installed and connected to the power supply in accordance with the
installation instructions before it is used.. (See: “Installing Your Beverage Center”).
The main power supply must be properly grounded.
This refrigerator must be positioned so that the plug is accessible. Never unplug youU unit often by
pulling on the power cord. Always grasp the plug firmly and pull straight out from the outlet.
Do not use an extension cord as this can negatively affect the performance of the unit.
When transporting the refrigerator, keep the unit in the upright position. Do not tilt the appliance
beyond 45° or place the unit in upside down position. Do not tip over.
Do not touch the cooled surfaces while the appliance operates, especially not with wet hands,
because the skin may stick to the cold surfaces.
It is recommended that the refrigerator is positioned away from any combustible sources such as
gas, petrol, alcohol, lacquer and banana oil, etc. The aforementioned objects should not be stored
in the refrigerator under any circumstances.
If the unit fails to cool properly, dispose of spoiled food as needed.
Unplug your unit before cleaning or before making any repairs. NOTE: If for any reason this
product requires service, we strongly recommend that a certified technician perform the service.
Repairs made by non-qualified personnel will void the warranty.
Do not defrost the appliance with other electric devices (hair dryer etc.) and never scrape the ice or
frost layer with sharp tools. Warning: Do not damage the refrigerant circuit.
The rating plate is inside the appliance or outside on the rear or side wall.
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not run cord over carpeting or other heat insulators. Do not cover the cord. Keep cord away
from traffic areas, and do not submerge in water. If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Repair or replace immediately all electric service cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length, the plug or the
connector end.
Do not operate your refrigerator in the presence of explosive fumes.
WARNING--Do not use the flame or catch the fire near the unit.
DANGER-Risk of fire or Explosion. Flammable Refrigerant Used. To Be Repaired Only By Trained
Service Personnel. Do Not Puncture Refrigerant Tubing.
Caution--Risk of fire or Explosion. Dispose Of Property In Accordance With Federal Or Local
Regulations. Flammable Refrigerant Used.
CAUTION – Risk Of Fire Or Explosion. Flammable Refrigerant Used. Consult Repair
Manual/Owner’s Guide Before Attempting To Service This Product. All Safety Precautions Must be
Followed.
CAUTION – Risk Of Fire Or Explosion Due To Puncture Of Refrigerant Tubing; Follow Handling
Instructions Carefully. Flammable Refrigerant Used.
Staple your receipt to your manual.
You will need it to obtain warranty service.
1. Interior Light
2. Glass Shelves (1)
3. Bclak Wire Shelf (2)
4. Adjustable Leveling Legs
5. Touch Control Panel
6. Tinted Double Pane Glass Door
7. Drip Tray in Back (not shown)
Parts and Features
5
F
1
2
3
4
6
3
English
1. evomeR all packaging material. This includes the foam base and all
adhesive
outside.
tape holding the beverage center accessories inside and
2. tcepsnI and remove any remaining packing, tape or printed
materials before powering on the Beverage Center.
tnorf eht ni detacol era hcihw sgel gnilevel owt sah retneC egareveB ruoY
corners. After properly placing your Beverage Center in its final position,
you can level your beverageand and wine center.
ruoy rewol ot esiwkcolc meht gninrut yb detsujda eb nac sgel gnileveL
Beverage Center or by turning them counterclockwise to raise your
Beverage Center. The Beverage Center door will close more easily when
the two front leveling legs are extended slightly.
ycneicfife mumixam eht ta skrow retneC egareveB ruoy taht erusne oT
it was designed for, you should install it in a location where there is
proper air circulation and electrical connections.
egareveb eht dnuora secnaraelc dednemmocer era gniwollof ehT
center:
Sides……………2" (50mm)
Top....................2" (50mm)
Back..................2" (50mm)
Do not over fill your Beverage Center for proper cooling.
Note: 4 tiaw ,nosaer yna rof detlit neeb sah retneC egareveB ruoy fI
hours before plugging it in.
Ensure the drip tray in the rear of the unit is in the proper position.
Installing Your Beverage Center
Unpacking Your Beverage Center
Proper Air Circulation
Leveling Your Beverage Center
Drip Tray
4
English
Electrical Requirement
Note:
A
a
a
a
Installation Limitations
Use of Extension Cord
WARNING:
5
English
Using Your Beverage Center
6
English
Shelving
(See Fig. #2)
To remove or replace a full-width slide-out shelf:
1. Gently tilt the shelf up and slide forward until the shelf has been completely
removed.
2. To replace the shelf, gently slide the shelf back.
Fig. #2
Normal Operating Sounds You May Hear
t The sound s of boiling water and gurgling or the slight vibrations are the
result of
the
refrigerant ci rculatin g through the cooling coils
.
t
Compressor
makes
operational
sounds when cycling on and
off.
7
English
Cleaning and Maintenance
Warning:
Caution:
To avoid electric shock, always unplug your beverage center
before cleaning. Ignoring this warning may result in dLUe
FRQVHTXHQFHV.
Before using cleaning products, always read and follow
manufacturer’s instructions and warnings to avoid personal
injury or product damage.
General:
Prepare a cleaning solution of 3-4 tablespoons of baking soda
mixed with warm water. Use sponge or soft cloth, dampened
with the cleaning solution, to wipe down your beverage center.
Rinse with clean warm water and dry with a soft cloth.
Do not use harsh chemicals, abrasives, ammonia, chlorine bleach,
concentrated detergents, solvents or metal scouring pads. Some
of these chemicals may dissolve, damage and/or discolor your
Beverage Center.
Door Gaskets:
Clean door gaskets every three months according to general
instructions. Gaskets must be kept clean and pliable to assure a
proper seal.
Petroleum jelly applied lightly on the hinge side of gaskets will
keep the gasket pliable and ensure a good seal.
Defrosting Your Beverage Center
Your Beverage Center is designed with a manual defrost system. The Beverage Center
surfaces will defrost, when the unit is unplugged. Water from the unit is disposed of
automatically, by means of being channeled onto a drip tray located on the compressor.
Heat transfer from the compressor causes this water to evaporate.
Power Interruptions
Occasionally there may be power interruptions due to thunderstorms or other
causes. Remove the power cord from AC outlet when a power outage occurs.
When power has been restored, replug power cord to AC outlet.
The unit will revert to the factory setting of 46ºF after any power outage. Reset your
temperature selection.
Vacation and Moving Care
For long vacations or absences, empty contents from Beverage Center, unplug the
unit and clean the Beverage Center and door gaskets according to “General cleaning”
section. Prop doors open, so air can circulate inside. When moving, always move the
Beverage Center vertically. Do not move with the unit lying down. Possible damage to
the sealed system could occur.
Proper Beverage Center Care &
Cleaning
8
English
Control Panel does not respond
Check if control panel is on.
Beverage Center Does Not Operate
Check if Beverage Center is plugged in.
Check if there is power at the ac outlet, by checking the circuit breaker.
Check if power pad is on.
Temperature appears too warm
Frequent door openings.
Allow time for recently added beverages to reach proper temperature.
Check gaskets for proper seal.
Adjust temperature control to the require cooler stting.
Temperature is too cold
If temperature control setting is too cold, adjust to a warmer setting and allow
several hours for temperature to adjust.
Beverage Center runs too frequently
This may be normal to maintain constant temperature in high temperature
and humid days.
Doors may have been opened frequently or for an extended period of time.
Check gasket for proper seal.
Check to see if doors are completely closed.
Moisture build up on interior or exterior of the beverage
center
This is normal during the periods of high humidity.
Prolonged or frequent door openings.
Check door gaskets for proper seal.
Beverage Center door does not shut properly
Place Beverage Center on a level surface.
Check for blockages.
Troubleshooting
9
English
