Loading ...
Loading ...
Loading ...
Part 1 – Introduction
11
- I (In): Connect an alarm-in device to this port.
(Mechanism: Choose between an NC (Normally
Closed) type or an NO (Normally Open) type) →
Connect a mechanical or electrical switch to the
alarm in port and the GND (ground) connector.
Alarm in range is 0V to 5V. In order to detect alarm
input from an electrical switch, the signal must be
higher than 4.3V from an NC switch or less than
0.3V from an NO switch and must last for longer
than 0.5 seconds.
• Install Bracket Assembly Hole
Secures the body on the bracket.
• NPT 3/4" Cover
Remove the cover to combine the NPT 3/2" pipe.
• Heater
Has a built-in heater that enables normal operation in
sub-zero temperature conditions.
• Check your local laws and regulations on making
video or audio recordings. The user will be held
liable for any violation of the law.
• When switching over from 12 VDC to PoE as the
power source, the system will be rebooted once the
power adapter is disconnected.
• Organize the power cable so that it will not cause
people to trip over or become damaged from chairs,
cabinets, desks, and other objects in the vicinity. Do
not run the power cable underneath carpet or a rug
or plug the cable into a power outlet shared by a
number of other devices.
I/O Connector
Alarm
In Alarm In
GND Grounding
Out
Alarm Out (Active Low -
Open Collector Output)
Audio
In Audio In
GND Grounding
Out Audio Out
Factory Reset
Only use the factory reset switch to restore the camera
to its factory default settings.
A factory reset will clear all camera settings congured
by the user.
1
Shut o the power supply.
2
Remove the dome cover and then press and hold
the reset switch down.
3
Hold the switch down and reconnect the power
adapter.
4
Once the device turns back on, wait 5 seconds, and
then release the reset switch.
5
The device will go through the resetting process and
reboot. All camera settings will be restored to their
factory defaults after the reboot.
Loading ...
Loading ...
Loading ...