Miele HR 1934-3 G DF Clean Touch Steel – Ranges

User Manual - Page 11

For HR 1934-3 G DF.

PDF File Manual, 124 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
IMPORTANT SAFETY INSTRUCTIONS
11
Temporary or permanent operation on an autonomous power
supply system or a power supply system that is not synchronized
with the grid power supply (e.g., island networks, back-up systems) is
possible. A prerequisite for operation is that the power supply system
complies with national and local codes.
The function and operation of the protective measures provided in
the domestic electrical installation and in this Miele product must
also be maintained in isolated operation or in operation that is not
synchronized with the grid power supply, or these measures must be
replaced by equivalent measures in the installation.
Slide the range's locking latch into place on the anti-tip device. The
locking latch must be noticeably engaged with the bolt of the anti-tip
bracket.
A damaged range can be dangerous. Always check for visible signs
of damage. Never use a damaged appliance.
The electrical safety of the range can only be guaranteed when it is
properly grounded. Compliance with this essential safety requirement
is absolutely mandatory. If in any doubt, please have the building's
wiring system inspected by a qualified electrician.
Proper installation: Make sure that your appliance has been
installed correctly and that it has been grounded by a qualified
technician.
To avoid damaging the range, make sure that the connection data
(voltage and frequency) on the data plate correspond to the
building's power supply before connecting the appliance.
When in doubt, consult a qualified electrician.
Installation and maintenance of the gas connection must be
performed by qualified installers, service agencies or gas providers.
During installation, maintenance and repair work, e.g. if the oven
lighting is broken, the range must be completely disconnected from the
power supply (see “Frequently asked questions”). The gas inlet valve
must be closed. It is only completely isolated from the supply when:
- The circuit breakers have been switched off, or
- the fuses of the electrical installation have been completely
removed, or
Loading ...
Loading ...
Loading ...