Loading ...
Loading ...
Loading ...
Network Speed Dome & Positioning System User Manual
28
Steps
1. Select the PT Mode as Auto.
2. Click Calibrate to synchronize the north of the device with that of the e-compass.
4.11 Set Power Off Memory
This function can resume the previous PTZ status of device after it restarting from a power-off.
Steps
1. Go to Configuration → PTZ → Basic Settings.
2. Select Resume Time Point. When the device stays at one position for the set resume time point
or more, the position is saved as a momory point. The device returns to the last memory point
when it restarts.
3. Click Save.
4.12 Set PTZ Priority
The function can set the PTZ priority of different signals.
Steps
1. Go to Configuration → PTZ → Prioritize PTZ.
2. Set the priority signal and delayed time.
Network
The network signal controls the device with priority.
RS-485
The RS-485 signal controls the device with priority.
Delay
It refers to the time interval of PTZ operation controlled by different signals. When the
operation with high priority is finished, the low priority signal controls the device after the
setting interval.
3. Click Save.
4.13 Set Rapid Focus
Rapid focus is a function to reduce time of focusing comparing with that of normal focusing. To
use the function, calibration should be done first. Rapid focus may not be supported by certain
device models.
Steps
1. Go to Configuration → PTZ → Rapid Focus.
2. Add scenes for calibration.
Loading ...
Loading ...
Loading ...