Falcon CLA90FXDFCR-CH Classic FX 90cm Dual Fuel Freestanding Oven/Stove Cream

User Manual - Page 36

For CLA90FXDFCR-CH.

PDF File Manual, 52 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
32
ArtNo.281-0026 - Front plinth
Hotplate check
Check each burner in turn. There is a ame supervision device
(FSD) that stops the ow of gas to the burner if the ame
goes out.
To light a burner, push in and turn the associated control knob
to the high position indicated by the large ame symbol (
).
The igniter should spark and light the gas. Keep holding the
knob pressed in to let the gas through to the burner for a few
seconds.
If, when you let go of the control knob, the burner goes out,
then the FSD has not been bypassed. Turn the control knob
to the O position and wait for one minute before you try
again, this time making sure to hold in the control knob for
slightly longer.
Oven check
Turn on the oven and check that it starts to heat up. Check
that the oven lights are working. Turn o the oven.
Note: The oven light bulb is not included in the guarantee.
Fitting
Fitting the Handle and Handrail (Classic FX)
Remove the 4mm Allen screws from the doors ( Fig. 11.1 ).
Fit the door handle and secure using the 4 mm screws.
n
The handle should be above the xings.
Remove the 4 mm Allen screws from the top corners of the
fascia (Fig. 11.2). Fit the front handrail in position and secure
using the 4mm screws.
Fitting the Splashback (Classic FX)
Position the splashback on the rear of the hotplate and secure
with the screws supplied.
Removing the oven door
To remove the oven door, open the door fully. Swivel the
locking ‘U’ clips forward to the locking position (Fig. 11.3).
Grip the sides of the door, lift upwards and then slide the
door forwards (Fig. 11.4).
Retting the oven door
To ret the door, slide the hinges back into their slots. Rotate
the locking ‘U’ clips back to t onto the hinges.
Fitting the plinth
Remove the 3 screws for the plinth mounts along the front
bottom edge of the range (Fig. 11.5). Fasten the plinth using
these screws.
Customer care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
Fig. 11.1
Fig. 11.2
Fig. 11.3
Fig. 11.4
Fig. 11.5
11. Final checks and ttings
Art No 215-0028 - Handrail fascia fixings
Loading ...
Loading ...
Loading ...