Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have nished.
34
OFF
ArtNo.090-0021 Hotplate removal
12. Servicing
n
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS. TURN OFF THE GAS SUPPLY
n
DO NOT modify this appliance!
n
Check the appliance is gas sound after completion
of service. When checking for gas leaks DO NOT use
washing up liquid – this can corrode. Use a product
specically manufactured for leak detection.
n
DO NOT use reconditioned or unauthorised gas
controls.
n
Disconnect from the electricity supply before
servicing, particularly before removing any of the
following: control panel, side panels, hotplate tray
or any electrical components or covers.
n
Before electrical reconnection, check that the
appliance is electrically safe.
1. Panels
1. To remove the control panel
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control knobs. Open the oven door. Undo the
4screws on the oven beak (Fig. 12.1). Remove the 3 xing
screws on the underside of the control. The control panel
should drop down slightly. It is held at each end by 2 holes in
the top edge (Fig. 12.2) that locate on the tags on the inner
panel.
Lift the control panel clear of the tags and pull the control
panel forward (Fig. 12.3). Disconnect the wiring from the
rear. Lift the panel clear of the cooker.
Replace all parts in reverse order. When replacing any
electrical connections refer to the wiring diagram.
2. To remove the side panels
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel. Undo the 3 screws securing the
plinth and remove.
Undo the lower retaining screw situated below the edge at
the panel front corner. Remove the side panel retaining screw
on the upper front edge and the 2 xings on the rear or the
side panel. Remove the panel by pulling it away from the
cooker.
2. Hotplate
1. To remove the hotplate
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove pan supports and burner heads. Remove the 10
screws holding the hotplate burners to the hotplate. Remove
the 6 screws holding the hotplate tray to the cooker (Fig.
12.4).
ArtNo.270-0032 - 90 Prof+ FX - Removing the control panel
ArtNo.270-0019 - Proplus tags 2
Fig. 12.1
Fig. 12.2
Fig. 12.3
Fig. 12.4
Loading ...
Loading ...
Loading ...