Loading ...
Loading ...
Loading ...
21
Water Tubing Connection Style 1: Press the colored outer ring
against the face of the fitting and gently pull the dispenser tubing
free as shown below.
NOTE: The water dispenser tubing remains attached to the left-
hand refrigerator door.
A. Outer ring B. Face of fitting
3. Before removing the left-hand side door, disconnect the wiring
plug located on top of the top hinge by wedging a flat-blade
screwdriver or your fingernail between the two sections.
NOTE: Do not remove the green, ground wire. It should
remain attached to the door hinge.
A. 3/4"Internal hex-head or
TORX T25 screws
C. Locator screws (do not
remove)
B. Ground wire (Do not remove)
4. Lift the refrigerator door from the bottom hinge pin. The top
hinge will come away with the door.
NOTE: It may not be necessary to remove the bottom hinges
and brake feet assemblies to move the refrigerator through a
doorway.
� Only if necessary, depending on your model, use a driver
with a #2 square bit tip or a TORX T25 screwdriver to
remove the bottom hinges and a 3/8" nut driver or a TORX
T25 screwdriver to remove the brake feet screws.
Reset Bottom Refrigerator Door
Hinge
For your convenience, the refrigerator doors have bottom hinges
with door closers. These closers allow the doors to swing fully
closed with just a gentle push.
IMPORTANT: So that the closers feature will operate properly, the
doors must be removed only when open to a 90° angle to the front
of the cabinet. If one or both doors were not at a 90° angle when
removed, the bottom door hinge must be reset.
RESET THE DOOR HINGE
1. Lift the door from the bottom hinge pin and place it on a flat
surface.
2. Using a driver with a #2 square bit, remove the bottom hinge
with the bushing from the cabinet.
A. Bushing B. Hinge base
Loading ...
Loading ...
Loading ...