Loading ...
Loading ...
Loading ...
2700G Series
Users Manual
6
Table 2. Display and Buttons (cont.)
Item Function
Push to go to setup and configuration
menus.
Push to make a selection. When the
Product is not in Configuration mode, push
to turn on the backlight. Push again to turn
off the backlight.
NPT Connector
Pressure Display
Engineering Units
Bargraph
Operation
The subsequent sections tell you how to operate the
Product. Push to turn on the Product.
The analog bar graph at the bottom of the display shows
the applied-pressure level relative to the full range of the
gauge.
Note
If you record a Tare value, the pressure shown
is not the actual pressure applied.
How to Setup the Product
Before you use the product, it is necessary to configure it
for your application. Push to go to the Setup menu.
Each time is pushed, the display goes to the
subsequent function. Push or to change the
parameter value. When a parameter is set, push to
exit the configuration menu or to move to the next
parameter.
Engineering Units
The Product’s default engineering unit shows psi. To
change this, push and to move through the
standard engineering units plus one custom unit/scale.
When the necessary unit shows, push or .
Pressure now shows in the chosen engineering units.
See the Specifications section for a list of available
1.888.610.7664 info@Fluke-Direct.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...