Loading ...
Loading ...
Loading ...
4
Removing a Sensor from a Z-Wave Network
Exclusion Instructions:
1. Initiate remove “Ring Alarm Glass Break Sensor” flow in the Ring Alarm mobile application – Select
the settings icon from device details page and choose “Remove Device” to remove the device. This
will place the controller into Remove or “Z-Wave Exclusion” mode.
2. With the controller in Remove (Z-Wave Exclusion) mode, use a paper clip or similar object and tap
the pinhole button. The device’s red LED turns on solid to indicate the device was removed from
the network.
Ring Alarm Glass Break Sensor – Factory Reset
Factory Default Instructions
1. To restore Ring Alarm Glass Break Sensor to factory default settings, locate the pinhole reset button
on the device. This is found inside the battery compartment on the back of the device after removing
the mounting bracket.
2. Using a paperclip or similar object, insert it into the pinhole, press and hold the button down for
10 seconds.
3. The device will rapidly blink green continuously for 10 seconds. After about 10 seconds, when the
green blinking stops, release the button. The red LED will turn on solid to indicate the device was
removed from the network.
Note: Use this procedure only in the event that the network primary controller is missing or otherwise
inoperable.
Identify Function
A controller application can send an Indicator command class with the Indicator ID 0x50 (identify) to
turn on the LED on the device.
Comm Test / Manual Wake Up
A comm test can be triggered by press the button on the front of the device. This will cause the device
to send a Comm test Notification. A solid Green LED indicates a successful comm test. cause the device
to wake up and send a Wake Up Notification. A solid Green LED indicates a successful comm test.
LED Behavior for Inclusion Blink Pattern
Smart Start Started Green LED blink quickly, repeated after a brief pause
Classic Inclusion Started Green LED blink quickly, repeated after a brief pause
Classic Inclusion Timed-Out Alternate red and green a few times
Inclusion Successful (Authenticated S2) Green LED on solid
Inclusion Not Successful (Self-Destruct) Red LED on solid
Loading ...
Loading ...
Loading ...