Loading ...
Loading ...
Loading ...
10
Operation
m
WARNING! Do not allow familiarity with the product
to make you careless. Remember that a careless fraction of a
second is sucient to inict serious injury.
mCAUTION! Always wear eye protection during
operation. Failure to do so could result in uids entering your
eyes resulting in possible serious injury.
This garden sprayer is designed for use with most consumer
grade home and garden chemicals, such as insecticides,
fungicides, weed killers, and fertilizers. Follow instructions
below for proper operation of this unit.
mWARNING! The garden sprayer is intended for
household use only.
Filling the Tank
mWARNING! Always follow the chemical manufacturer’s
instructions printed on their product labelling for use, cleaning,
and storage. Clean thoroughly after each use, following
the instructions in the Maintenance section of this manual.
Chemicals should be stored out of the reach of children.
Failure to do so may result in serious personal injury.
Liquids to be sprayed must be as thin as water. Thicker liquids
will not spray properly. Follow the instruction below to ll the
tank with proper solution. You can also premix the solution and
pour it into the tank, using a funnel if needed.
mWARNING! If powder detergent is desired, make
sure to dissolve the powder in water completely to avoid any
clogging.
NOTE: If using a measuring container other than the cup, or if
using a funnel to ll the tank, be sure to thoroughly clean and
rinse these items after use. If premixing the spray solution,
rinse the container used for mixing.
1. Turn o the unit and remove the battery.
2. Unscrew the measuring cup and remove it from the tank
(Fig. 5).
3. Fill the tank with the desired amount of water
(up to 1 gallon).
NOTE: DO NOT overll the tank.
4. Measure the recommended amount of solution with the
measuring cup. The cup may be used for measuring up to
4 oz (Fig. 6).
5. Carefully pour the measured solution into the tank.
6. Rinse the measuring cup with clean water. Screw it back
onto the tank, making sure it is tightened securely.
7. Reinstall the battery pack.
NOTE: It is important to thoroughly clean the unit after each
use. Allowing liquid to remain in an idle tool for an extended
period may cause its moving pieces and connectors to
seize up.
Starting + Stopping
mWARNING! Always remove battery pack from your tool
when you are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal injury.
1. Insert the battery into the battery compartment on the rear
of the sprayer housing until the battery clicks in position
(Fig. 7).
Fig. 5
Measuring
cup
Tank
Fig. 6
Measuring
cup
Fig. 7
Battery
compartment
Loading ...
Loading ...
Loading ...