Loading ...
Loading ...
Loading ...
Performance Series IP Camera Software Configuration Guide
86
If the power is disconnected during firmware upgrade or if there is unknown reason causing
abnormal LED status, and a Restore cannot recover normal working condition, you can
perform the following steps to activate the camera with its backup firmware:
a. Press and hold down the reset button for at least one minute.
b. Power on the camera until the Red LED blinks rapidly.
c. After boot up, the firmware should return to the previous version before the camera
hanged. (The procedure should take 5 to 10 minutes, longer than the normal boot-up
process). When this process is completed, the LED status should return to normal.
Configuring User Accounts Settings
Go to Setup System Setup User Accounts.
This section describes how to create multiple accounts and grant privileges to these
accounts.
Account Management
Figure 8-5 Account Management
The administrator account name is “admin”, which is permanent and cannot be deleted.
The administrator can create up to 20 user accounts.
To create a new user:
1. Select New user from the dropdown list.
2. Enter the new user’s name and password and confirm the password. Some, but not all
special ASCII characters are supported. You can use “!?@#$%=+*-_:,.&^~” in the password
combination.
3. Select the privilege level for the new user account. Click Add to enable the setting.
The privilege levels are listed below:
Loading ...
Loading ...
Loading ...