Loading ...
Loading ...
Loading ...
7
The machine is heavy, be careful when removing it from the shipping container! Failure to comply may
cause serious injury and/or damage to the sander and/or property!
Your DELTA
®
Heavy Duty Oscillating Bench Spindle Sander comes packed in a single container. Use a safety strap to
avoid tip-over when lifting machine. Check shipping carton and machine for damage before unpacking.
Open the shipping container. Carefully remove packaging materials, parts and machine from shipping carton. Always
check for and remove protective shipping materials around motors and moving parts. Lay out all parts on a clean work
surface and check that all parts are present and in good condition:
PRODUCT SPECIFICATIONS
FUNCTIONAL DESCRIPTION
Heavy Duty Oscillating Bench Spindle Sander is designed for sanding or polishing flat, round, or curved surfaces on
wood and plastic materials.
UNPACKING
Oscillation rate 29 strokes/min
Oscillation stroke 15⁄16" (24 mm)
Spindle Speed 1720 Rpm
Motor ½ Hp, 110 V, 7.5 A
Table Size 14 ½ “ X 14 ½ “ (368 X 368 mm)
Table Tilt 0° to 45°, 0° to -45°
Spindle Size Range ¼ “ - 3" (6.2 - 50.8 mm)
Dust Chute 2" (50.8mm) with 4" (101.6mm) Adapter
Base Dimensions 14 ½ “ X 14 ½ “ (368 X 368 mm)
Weight 81 lbs (37 Kg)
DESCRIPTION (QUANTITY)
Oscillating bench top spindle sander (1)
2" to 4" dust port adaptor (1)
1/4" sanding spindle (1)
1/2" sanding spindle (1)
5
/8" sanding spindle (1)
1 ½" sanding spindle (1)
2" sanding spindle (1)
1/4" sanding sleeve (1)
1/2" sanding sleeve (1)
5
/8" sanding sleeve (1)
1 ½" sanding sleeve (1)
2“ sanding sleeve (1)
3/4" oblong table insert (1)
3/4" round table insert (1)
2"oblong table insert (1)
2" round table insert (1)
10-12 mm wrench (1)
14-17 mm wrench (2)
Compare the items to inventory figures; verify that all items are accounted for before discarding the shipping box. Report
any missing or damaged parts to your distributor or dealer. Prior to tool assembly and use, read this manual thoroughly
to familiarize yourself with proper assembly, maintenance and safety procedures.
Remove any protective materials and coatings from all of the parts and the drum sander. The protective coatings can be
removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need redone several times before all of
the protective coatings are removed completely.
If any parts are missing, do not attempt to plug in the power cord and turn “ON" the machine. The
machine should only be turned “ON" after all the parts have been obtained and installed correctly.
Loading ...
Loading ...
Loading ...