Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/55870881-lt-3301-al/bg8.png)
LT-3300 Dimmer/Switch
8
About Description
Conguration Button
LED
Effect
LED Color Duration
Press / Hold # Press / Sec
Clear Notications Clears the RGB Bar of any notications. Press 2x N/A N/A N/A
Inclusion / Exclusion 3x Tap of Conguration Button (30s timeout) Press 3x Pulse
Blue
(Default)
See desc
Z-Wave Signal Test Tests the signal strength of the dimmer. Hold 5-10s Solid Green N/A
Conguration Button Command Features
Factory Default
You may factory reset the LT-3300 by holding down the Conguration Button and the Up Paddle at the same time for twenty
(20) or more seconds. The LED Bar will initially turn green, then turn yellow, and nally turn Red and blink three (3) times to
conrm. However, we recommend using a certied Z-Wave controller to remove the device from your network before factory
resetting the LT-3300. Only use either of these procedures in the event that the network primary controller is missing or
otherwise inoperable.
Z-Wave Signal Test
Pressing and holding the “Conguration” button from 5 to 10 seconds will display the Z-Wave signal strength of the LT-3300.
When the conguration button is released the LT-3300’s status LED will display either “Green = Good Signal”, “Yellow =
Weak Signal”, or “Red = No Signal”. If Yellow or Red are displayed, it is recommended to add additional Z-Wave nodes to the
network to assist in building a robust Z-Wave mesh network.
Z-Wave Long Range:
The LT-3300 supports Z-Wave Long Range and can be included into a network with compatible Z-Wave Long Range hub/
gateway.
To include via Long Range, enable Long Range support in your hub/gateway and add the DSK into the provisioning list. Then
apply power to the LT-3300 and wait for the device to be added to the network.
Note: The URC TRF-ZW10 gateway does not support Z-Wave Long Range.
Parameters:
The LT-3300 has a number of parameters available to give the user a true customized experience.
Some of the highlights include: changing the LT-3300 from a switch to a dimmer, changing the dimming speed, min/max
brightness, LED status bar color/animation, default power on behavior, double tap to max brightness behavior, and so much
more.
All the parameters can be congured directly within the URC Accelerator software, or you can visit “www.urc-
automation.com/products/lt-3300” to see the full list of available parameters.
Loading ...
Loading ...