Loading ...
Loading ...
Loading ...
9 maintenance and care
Charcoal filter
• The charcoal filter should only be used if you want to use
the hood in the recirculation function.
• This filter cannot be cleaned or reused.
• As a general rule, the activated charcoal filter should
be changed once every four months.
• Fitting - Fig. 5
Fit one charcoal filter on the left and one on the right so to
cover the plastic grids that protect the fan wheel.
• Always specify the hood model code number and serial
number when ordering replacement filters. This information
is shown on the registration plate located on the inside of
the unit.
• The charcoal filter can be ordered from your local Service
Center.
Fig. 5
Charcoal filter type AR500CF
Symptom
Check that: The hood is connected to the electricity supply.
Check that a fan speed has been selected.
Solution
The cooker hood will not start…
The safety cut-out device has been tripped.
Turn off the hob and then wait for the device to reset.
If the hood has been installed below the heights indicated in the
installation instructions the motor will cut-out frequently which will
damage the hood.
The cooker hood has switched off
during operation…
The cooker hood is not working...
Check that: The fan speed is set high enough for the task.
The grease filters are clean.
The kitchen is adequately vented to allow the entry of fresh air.
If set up for recirculation, check that the charcoal filter is still effective.
If set up for extraction, check that the ducting and outlets are not
blocked.
If after all these checks, the problem persists, contact your local Service Center, quoting the model and serial number.
Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is
not a mechanical or electrical breakdown.
What to do if
If your appliance fails to work properly please carry out the following checks.
Loading ...