Loading ...
Loading ...
Loading ...
-13-
Preparation
Inserting/Replacing the Battery
Use only alkaline batteries.
To open the battery lid 4, press the latch 7 in the direction of the arrow
and remove the battery lid. Insert the supplied batteries.
When inserting, pay attention to the correct polarity according to the
representation on the inside of the battery compartment.
When the batteries are low, the laser lines will flash quickly for a few
seconds.
Always replace all batteries at the same time. Only use batteries from
one brand and with the identical capacity.
Remove the batteries from the tool when
not using it for extended periods. When
storing for extended periods, the batteries can corrode and discharge
themselves.
2)
Conductive pollution occurs, or dry, non-conductive pollution
occurs which becomes conductive due to condensation which is
expected. In such conditions, equipment is normally protected
against exposure to direct sunlight, precipitation, and full wind
pressure, but neither temperature nor humidity is controlled.
GLL25-10 2610050718 04-18.indd 13 4/9/18 8:56 AM
Loading ...
Loading ...
Loading ...