Loading ...
Loading ...
Loading ...
14
Luce Use, Care, and Installation Guide
LUCE
WALL
CORE
Installation Instructions
Mounting the Hood
1. Measure from range top to hood bottom and mark line A.
(24” minimum from range top).
2. Plum and mark center line.
Mark mounting height line B. (14-5/8” from line A)
Mark mounting spread from C/L on line B 8-15/16”
3. Fasten (2) M4 x 1-1/2" screws into studs on line B. Do
not fasten screws all the way, leave approximately 3/8”
exposed.
NOTE: Wood blocking may need to be added behind the
drywall if no studs are present. Wall anchors may also be
used but check local codes for compliance. Failure to use
suitable wall anchors and screws to hold the weight of the
hood could result in personal injury or damage to cooking
surface or counter.
4. Remove tape and securing electronics mounting bracket to
hood. Reposition electronics mounting bracket as shown in
FIG. C and secure to motor housing using (2) pre-installed
screws (FIG. C3).
5. Remove the (2) aluminum mesh filters.
6. Hang hood onto the mounting screws and hand tighten
each screw (FIG B.)
7. Center and attach duct cover mounting brackets to wall
just below the ceiling or sot using (2) M4 x 1" screws*.
8. Install electrical (FIG. C2) and duct work. Seal duct work
with aluminum duct tape.
9. Power up hood and check for leaks around duct tape.
10. Place telescopic duct covers onto hood and extend inner
(top) duct cover upwards and secure to duct cover bracket
using (2) M4 x 8 screws. Reinstall mesh filters.
*If using hood in recirculating mode you must secure air
diverter plate onto wall before installing duct work and
duct covers. You will also need to install charcoal filters and
brackets. Turn to ductless recirculation section for more
details.
FIG. B
26” min.
8-
15/16
”
14-
5/8
”
Duct cover bracket
Cable Lock
2
1
3
Motor Housing
FIG. C
Loading ...
Loading ...
Loading ...