Loading ...
Loading ...
Loading ...
Mounting
Mounting on ATV or UTV
Always consult technical personnel if you are in doubt about installation.
You must work with an assistant to mount the sound bar due to its heavy weight.
Use only the supplied accessory for mounting. Using other mounting methods may void the warranty.
To ensure safety of the mounted sound bar, always check the mounting conditions (e.g. mounting
straps) of the sound bar before each vehicle ride.
Spring washer
Upper part of
the clamp
Lower part of
the clamp
Rubber pad
Mounting bar
Lower part of
the clamp
Sliding block
1. With correct orientation, attach a sliding block to the
lower part of a clamp using a proper hex wrench
(not included). Make sure not to tighten the block for
subsequent insertion into the channel.
2. Find the sliding channel (groove) on the top panel of
the sound bar. Correctly orient the sliding block and
insert it into the channel from either end of the channel.
Then slide the clamp to a proper position and tighten it
with a hex wrench.
3. Attach the supplied rubber pads for secure clamping
and abrasion prevention.
4. Tighten the upper clamp to the lower clamp with a hex
wrench. Make sure the supplied spring washers are
used to provide more stable bolt tightening against
vibration.
Repeat the steps above to secure the sound bar with
the other clamp.
4
Loading ...
Loading ...
Loading ...